Hi Guys,
since yesterday i am trying to get the DFU with Softdevice S110 (BLE) v7-alpha3 working but haven't succeeded yet. My process is the following:
s110_nrf51822_7...
Hi All,
i would like to know about
1) what is channel in nrf51288?
2) is there any mathematical relationship between channel no and pin no as in ble_app_hrs
example channel...
Hi,
I use UART bootloader SDK example(dfu_dual_bank_hci) to do update firmware on EK PCA10001 board,it can work ok.But i changed the HCI_SLIP_UART_RX_PIN_NUMBER and HCI_SLIP_UART_TX_PIN_NUMBER...
Hi. I have been trying get a notification through ANCS.
I have created an app which is made by modifying ble_app_ancs sample.
It works basically but there is one problem...
Hello,
I'm using the nrf51422 with 210 softdevice.
I'm trying to figure out a way for the receiving slave device to go to sleep when away from the master, but to wake...
To be able to upgrade FW through UART, a bootloader for nrf51822 is required in my project. I have tried out the example bootloader in SDK. But this example is using softdevice...
Hi.
I have 3 Dev Board's MBN52832DK and Ill like like to upload the BT Mesh example into those boards and I'm not very expert on this topic, dis you have any Webminar or...
Hello,
i was wondering about the stated antenna efficiency here:
infocenter.nordicsemi.com/index.jsp
The very poor values (< 20%) provided for the efficiency do not...
Hi,
I have experience with the ESP 16/32, pi zero and BOSH XDK. I have been working on some IOT mesh stuff and I have a good product idea that I know I can build with your...
Our project is using SDK 15.3.0 on a nRF25840. Similar to this post , we'd like to be able to re-bond if the bond has been deleted on the Nordic side but not on the phone...
Hello,
I want to test nrf5340 external lfclk, but I don't how to test it.
sdk:1.5.0
board: nrf5340dk without hfclk
I want to use external lfclk to generate 1khz...
Hi Team,
I am developing a device using nrf52832. I want to configure the gpio used to wake up from system off mode to enter into gpio interrupt handler on wake up. How...
Hi ,
I need to add an I2C device in project , I referred sample project i2c_scanner .
changes done in nrf9160dk_nrf9160ns.overlay file
code added in prj.conf
...
We are using PPK II with nRF52840-DK and in zigbee case we are getting two different kinds of reparative pulses
1. Pluse_1 -> Amplitude = 17.52mA ; Ton = 200us & Toff =...
Hi All,
We found a problem about the NRF52832AA connect parameter update problem on some cell phones.
1. While the app connect to our device, parameter update not only...
I'm doing a load test on radio. In 1Mbps mode, the transmission time of the radio with different loads.
For a packet size of 65 bytes, I used this test:
Use the logic...
