Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
I'm a user using nrf52832 s132. I am adjusting the BLE connection range. scan_init is init_scan.connect_if_match = false and adv report tried to connect the device to if(p_adv_report...
Short description: After establishing a BLE connection between two nRF52840 based boards (both running Zephyr) and starting data transmission (one transfer about every 500...
Hi Team,
We're using nrf52833, nCS V1.9.1 need information on for following things,
1. We need information on API from nCS SDK which un-provision's the device and...
Environment: nRF connect SDK 1.9.1
Hardware: nrf5340 dk
We try to send data by BLE NUS. According to excemple Bluetooth: Peripheral UART and Bluetooth: Throughput , we...
Hello Nordic team and fellow developers,
We are now making our custom board, and have a few questions:
1. MAGPIO gets 1V8 internally, but COEX needs it from VDD_GPIO....
I have the DFU Trigger code added to my application, and am using nrfutil to upload the package over USB. If I press the reset/DFU button on the dongle the process works fine...
Hi,
nrf-command-line-tools-10.16.0-x64.exe
If calling NRFJPROG_read_connected_emu_snr(..) ,when more than one JLINK is connected to the computer, a selection window...
According to the nPM1100 (PMIC) datasheet, the absolute maximum rating of VOUTB = VINT +0.3V.
VOUTB is the output of the internal DC/DC buck converter.
VINT is supplied...
NCS 2.0.0
Our application is using an nRF52833. Everything is running except measuring a voltage. I am looking for a simple SAADC sample to read a single-ended voltage on...
Following this link -> developer.nordicsemi.com/.../ug_matter_gs_adding_clusters.html I have set up two endpoints on a Matter end device (nRF52840 DK) and some commands and...
Hi, after installation the nRF Connect for VS Code Extension Pack (guided by the Video from Nordic), I can not see the Welcome Icon on the left side:
I restarted VS Code...
Hi,
After making a 802.15.4 poll request for data and receiving an ACK message which is not followed by any data message the confirm callback never occurs. I have verified...
this is (NRF connect app) for Android mobile
in android phone i am using NRF connect mobile app, in android phone Bluetooth device MAC address is showing, but i install...
My application originally used the ncs version of 1.5.0, and the configuration project used the dts file of nrf5340dk. When I need to change the rts pin of uart0, I just need...
