Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello,
I am looking in the SDK how to get the binding table on the local device. I don't find in the API which
function could give me this table to know the bindings done...
After more than a week of trying different options, settings and changes my AWS_IoT app for nRF9161 is not working. All I get on Serial monitor is this:
*** Booting My Application...
Hello,
i am fighting with getting an simple NUS running. I just followed on the provided example.
But got the error message via RTT: app: ERROR 4 [NRF_ERROR._NO_MEM] at...
I am using nrf54L15-PDK, the GPIO has output voltage at 1.8v, though the supply voltage is 5v. I want to configure OLED display with my board but the GPIO is giving me 1.8v...
I'm looking for an example where the firmware is updated using "DFU over UART from the bootloader" compatible with nrf5340
In my application there is no external SPI memory...
We are currently testing our product which has an nRF9151 SiP.
In order to provision a chip to nRF Cloud, the IMEI and HWID is required. We are already familiar on how to...
I am developing a product that uses Gazell and USB. During development, I am using the nRF52840 due to availability. For mass production, I will use the nRF52833 to reduce...
Hello Nordic Team,
I am working on a project that involves scanning QR codes on an Android device and transferring the scanned data to an nRF52840 DK using Bluetooth Low...
Hi Support Team,
I am encountering various problems with the Developer Academy example found here:
https://academy.nordicsemi.com/courses/bluetooth-low-energy-fundamentals...
Hello,
I am using NCS v2.8.0.
In this, when I configured the application to use OOB legacy pairing only mode, the build process failed.
Following is the configuration...
In our firmware we use BLE together with ESB using the MPSL timeslot API, with the implementation inspired by this example: https://github.com/too1/ncs-esb-ble-mpsl-demo However...
Hi,
I am trying the sample code in this regard. I have changed the I2C pins in the overllay file and bme register address to 0x77 as follows. It seems working but I have...
I am using nRF52840/nRF52833 (raytac module, original board). With the current nRF Connect SDK, is it possible to disable NFC and use ports (P0.09, P0.10) as GPIO?
I am...
Hello,
we are currently in the process of verifying the nRF LwM2M Client, specifically focusing on the Queue Mode functionality. During our testing, we encountered an issue...
