Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
Hi,
we are currently using NCS 2.0.2 on nRF52840 .
Is it possible to disable uart1 via pinctrl or another library during runtime and re-configure the rx/tx as gpios? ...
Hi,
I have met some problems while building the environment of pc-ble-driver-py. Error occurs in this command. The error points that I do not install git, but I have installed...
Hi, I'm new to nrf development. I was able to successfully install the SDK and toolchain using the toolchain manager. But when I'm trying to build a sample project "Blinky...
Target: nrf52 dev kit
Soft device: s132_nrf52_7.2.0_softdevice.hex
SDK: nrf5 sdk 17.1.0
Environment: IAR
Example modified: ble_app_rscs I am trying to modify the example...
Hello,
I am currently developing an LTE/LwM2M application on a custom board using the nRF9160 and NCS version 2.1.0. The application is almost finished and works great,...
Hi team,
We are using NRF52833 with PCA10100 on it and soft device version is s140.
We are advertising with both service data and manufacturing data.
1. Initially when...
There are two UART interfaces in nRF52840:
We have refer to nRF52840 and nRF52840 DK materials, but we found only one UART connection reference.
We want to know how to...
Hello, team.
I have some questions about reset restriction of nrf9160.
Q1. Does the restriction timer(30minutes) still run after +CFUN=0?
Q2. What is the exact meaning...
Hi guys. I read this thread answered by Einar Thorsrud. devzone.nordicsemi.com/.../direct-advertising-example
"HID mouse example uses direct advertising, but only when it...
I am using nRF52840 dongle with raspberry pi 4 to create a thread network. I downloaded nRFconnect for desktop to flash the hex files into the dongles.
I successfully flashed...
Hello Nordic support,
I understand that BLE stack is provided in nRF5 SDK as SoftDevice hex file and the flash area is fixed for the softdevice. I would like to understand...
Hi,
I'm trying to implement a circuit using a brand new nRF52840 chip. The chip has no bootloader included yet. When I try to burn bootloader, the chip is not detected by...
Hi
1. What certification is required to sell the products developed by nRF9160 in Japan?
2. What certification is required to add an antenna to nRF9160 in Japan? Do I...
