Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am developing a pair of central and peripheral applications that will be part of a hardware suite that will undergo emissions testing and certification. We are using the...
I'm successfully using nRF52832 on custom designed PCBs. I've been trying I2C communication (nRF is the Master) using the TWIM driver. This has worked successfully at 100kHz...
Hello all
I suspect this is a simple coding error that was I not a complete beginner I'd know how to fix.
I'm using the YouTube series to work through here : nRF5 SDK...
Hi,
i have add the group filter specific to the nRF5340 Audio application to the west manifest file by running the following command:
west config manifest.group-filter...
Hello everyone,
I am using Thingy53 device, For the first time when I switched on the device, The LED light blinked twice but since after that it is not blinking also...
Hi!
I'm testing ubidots, which require a 35 character long username to connect with MQTT. This fails, and mqtt_connect gives me error -12 ENOMEM. The same code works fine...
I am working on a nRF52833 chip and using nRF SDK 16.0.0 version. I need to analyse the memory footprint of my project for which I would need access to .map and .axf files...
Hi
I'm new to programming and recently started working on nrf52832.
I'm working on a wearable device that monitors patient's vital. I'm using MP34DB02 digital microphone...
This might be a dumb question. I have a pretty simple modification of the mqtt_simple sample application on an nRF9160DK where I have subscribed to multiple topics. I see...
Please point me to a good tutorial page or video beside "tutorial on SSL.com". I would like to learn step by step on how to make certificate like this for nrf9160 using http...
I'm trying to figure out a way to monitor the TX data when using the SPIS. When the slave is requesting to send data back to the master, we are asserting a pin. When all of...
Hi,
I'm implementing a composite hid device using nrf connect sdk 2.0.0, I do checked the hid-cdc and hid alone samples but there's still few problems that confused me...
Hi , i have been trying to implement the DS18B20 sample of zephyr taken from GitHub
I am having a lot of trouble in building the code , it comes up with very different errors...
