What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hi
I have a question about using gazell link layer and paring library with concurrent timeslot api. I try to do this but i have the hard fault handler after invoked nrf_gzll_init...
HI,
I want to use PWM to control various hardware (LED's, etc ..) so I started off from the suggested PWM code example, found in this forum + modified it as I want to use...
Hi,
Im trying to run a beacon sample code using VS code on nrf52832dk board. Initially, I tried running with the latest SDK available 3.0.0, but I faced MSPL assert error...
Hello,
I am measuring the sleep current consumption of a custom board using the PPK2, and I am observing a significant discrepancy between the two measurement modes.
...
Hello,
I am currently evaluating and trying to conform to the regulation regarding the RED EN 18031 vulnerabilites checks and I am having some problems due to that the sbom...
On the previous nRF52833, the CPU cannot function normally during flash write or erase operations.
With the nRF54 series upgraded to RRAM, does a similar limitation still...
Dear Support Team,
I'm developing a Matter remote controller and want to implement Scenes Cluster Client functionality. When a button is pressed, the remote should recall...
I am using QSPI NOR flash (MX25R6435F / MX25L51245G) with nRF5340 . I am trying to enable 4-byte address mode using the SFDP BFP table in the device tree overlay.
When I...
Hello all,
I'm currently developing an application using the ESB protocol on a nrf52840.
I'm trying to calculate the expected current consumption in the different stages...
Hi,
I am working on a project with channel sounding requirements and I have collected some test data. I am using the example codes Bluetooth: Channel Sounding Initiator...
I am developing an application using nRF52833 + nRF5 SDK + S140, and I encountered a strange issue. When I perform an OTA update from a firmware that does not initialize the...
Hi there,
I am using MDBT dev kit based on MDBT53-1M module. I have a simple application of reading an SD card and printing the data on the LOG. While the current application...
