Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I have a Raytac module which contains a nrf52810 AT module in it hooked up to a micro via Uart, so i can send and receive AT commands and data. I'm trying to connect to my...
Hi, I have developed one custom application and enabled DFU features in it.
With the help of nRF Toolbox mobile application, I am changing the application code.
Now I...
I just installed the nRF9160 DK but it showed yellow exclamation marks at the CDC and BULK interfaces. I'm using Windows 7. I couldn't find where these drivers are.
Anyone...
How do I use PWM on a GPIO on port 1 on SDK 15.2? The PWM library examples only sends in the pin number and seems to assume port 0. This answer seemed a bit complex and I...
Dear all,
I modified the example "ble_app_uart" based nRF5_SDK_15.2.0_9412b96 and S132 SoftDevice v6.1.0 to do some tests . But now I encounter the disconnect reason 0x22...
Hi guys, help me please.....
I want to build a device act like both keyboards and mouse. I've made some progress that the device can connect to my PC(win10) successfully...
Hi all
I developed my custom NRF52840 pcb followed by nordic design..i have done program flashing.Blinky LED also working.But Beacon advertising is not working.while flashing...
Dear Sir
I was working with nrf52832.
.SDK version ------------- 'nRF5_SDK_15.0.0_a53641a'
Soft device - s132_nrf52_6.0.0_softdevice.hex
I was handling a scenario...
I measured the consumption of nrf52832, in deep sleep mode, the consumption is 32uA, the question is: there is a pulse about 5mA every 39ms, is that all right? what's the...
In the screenshot above, although the CMSIS 5.4.0 SoftPack is installed, when compiling, it means that there is no SoftPack.
And I notice deprecating support for CMSIS Pack...
Hello,
I've just been following this tutorial for beginners about advertising. I've got it to work fine. I am able to advertise specific data and this can be viewed through...
OS in development environment ：Windows7 HARD :(Taiyo Yuden)EBSHSN Series Evaluation Board : Central / Peripherals CPU :(Nordic) nRF52832 / ARMR Cortex?-M4F 32 bit processor...
