Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
HI,ALL！
I tried to add a RTC wakeup funtion to my ble device, so i add the code of the Nordic board example named "rtc_example" to my program.
But it turned out that my...
Hi,
I am trying to create a simple network using nrf5340 boards using BLE and Visual Studio Code as follows:
1. Scenario 1 - Very simple network: one nrf5340 communicates...
Hi,
I want to have a nrf52840 communicating with a Raspberry Pi over USB. The single USB port of Raspberry Pi 3A+ is also used by a LTE modem. So I have an USB hub IC to...
Hi,
I am currently want to re-compile my code that actually works in previous version of sdk. But now, in this current version (v.2.2.0), I got error zephyr.h not found...
Hi,
i am running the peripheral uart exsample on a thingy52. using a usb/ttl converter on my PC and conect it to P0.2 and P0.3.
then using Terminal program on pc and nrf...
Hi All,
We have a product that requires the use of the file system Fatfs, which is plugged into the external SPI FLASH. Therefore, the hardware platform used is: n52832...
Hi,
I got 3 nrf52840 demo board. I want to use nrf Programmer v3.0.4 to write softdevice S340 to flash.
When I add file, I can see my S340 hex in file memory layout. But...
I'm working on a project that uses BLE, NVS storage (for some serial number data and a few other variables) and littlefs, for storing log data that a client can then access...
When I look at my toolchain manager, it looks like nRF Connect SDK is installed:
And, I can click the "Open VS Code" button and browse to one of the examples (the uart...
A colleague of mine was playing around with the modem settings for a 9160 and now the device refuses to connect to the cellular network.
I've reflashed the device including...
Hi,
I try to use Soft Device Controller (sdc) on my application. I use VS Code, Zephyr and NRF Connect SDK v2.1.2 .
I got error during build. Could please help me on this...
Hi
I am working on Nrf5340 . So, I need to Know the procedures which I need to follow for nrf5340 and how can I do that on NRF Connect SDK.
Kindly help me to get it done...
Hi
can we check BLE Mesh is Provision or not ?
actually I want to add one print statement whenever provisioning will not happen only for testing purpose. like while provisioning...
hi,I used the dfu usb_serial project to update the application， But I don't want to install the nrfutil.exe software because it is too cumbersome for the end customer。 May...
Hi team,
I am using nRFConnect SDK v2.2.0, and developing multi-threaded application which has BLE and ethernet.
I had three thread, each has the same priority of 7. ...
