What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hi
I have a question about using gazell link layer and paring library with concurrent timeslot api. I try to do this but i have the hard fault handler after invoked nrf_gzll_init...
HI,
I want to use PWM to control various hardware (LED's, etc ..) so I started off from the suggested PWM code example, found in this forum + modified it as I want to use...
Reading The adhoc smart waste solution uses the nRF9160 SiP I tried to reproduce the mention 6 µA with LTE-M in eDRX with an interval of 655 s.
I use
CONFIG_LTE_EDRX_REQ_VALUE_LTE_M...
Hi,
We use PPK2 very conveniently as a logger for testing.
How about adding the supply voltage as display options also?
We hope you will consider this.
Thank you...
Hi dear,
It is possible to establish parallels multi connection to different J-LINK's devices serial numbers via nrfjprog.dll, or any other automated way ?
We successfully...
Hello, I'm making a breakout board with nrf52832 qfaa. I used chip antenna (2450AT18B100E) and followed Nordic reference layout. I am getting around 60m range in an open environment...
run nrf Connect for bluetooth Low Energy Standalone
connect PCA10040 board
select "server setup"
press "+ New service" which adds a New Service
press "> New Service...
Hi, I am currently learning to retrieve location using thingy 91 and location example from nrf SDK. When I run it, I got this message (below).
After doing some research...
I want to change the data in the registers of Radio peripheral when the Radio at the state of "Disabled",but with no respons.
Only if I repower the Radio it works,but why...
Hi all !!!
I am trying to program the bootloader and softdevice using the J-Flash software, but I get this error, how can I fix it?
Board: PCA10056 (NRF52840)
SDK: 17...
Hello,
I'm currently using the nrf9160 for a university project and I'm having problems with connecting my custom PCB with nrf9160 to nRF Cloud using the asset-tracker-v2...
Hello:
I want to ask you, we want to add our own custom data in the Ble scan response package, including Company ID,
we know Nordic's company Id is 0x59, can we change...
Hello,
I am trying to connect the nrf9160 dk with the SLM application to our STM32.
The idea is to use the nrf9160 modem to connect to NB-IoT/LTE-M and control the modem...
Hi there,
I compiled a QSPI test program on board nrf52840dk. The SDK version is 1.9.1. Everything works fine. I would like to upgrade with SDK 2.2.x but I have several...
Hi Nordic.
I am developing with nRF52832DK and SDK 17.1.0
And it's connected with my Qualcomm board.
I want check GPIO input interrupt and output settings.
But...
Is it possible to view RTT console outputs in vscode during a debug session? I would like to see RTT console outputs right from the start, e.g. from bootloader, preferably...
