Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
In my current project I have two type of boards. Some have the external 32kHz crystal mounted and some not.
I am trying to detect the presence of the external crystal...
I am looking at using SRP in our application and I am looking through "nrfxlib/crypto/nrf_cc310_mbedcrypto/include/mbedtls_extra/mbedtls_cc_srp.h".
There is a parameter...
Hi. I think I did a huge error by uploading the soft device S140 after erasing all.
Which lead to the device being locked. I tried to use J-link GDB Server still the issue...
Hello! I have a question about the work of nRF52 with memory, why does it work so crookedly? The first situation. We have a static void nus_data_handler (ble_nus_evt_t * p_evt...
I'm facing an issue with the build failing when using the gcc-arm-none-eabi-9-2019-q4-major toolchain on Windows 10. I saw a similar post here, github.com/.../22060 , but...
Hi,
I am struggling to get my WS2812 LEDs to work with my current setup. I am aware that I need logic level shifters, but Im still not sure if my hardware or software is...
Hello,
In our project, we have a BMD-300 module, which contains a nRF52832 chip, and a nRF52840DK. The BMD-300 module is used as peripheral and the nRF52840DK is used as...
Hi!
I would like to send and receive IEEE 802.15.4 compliant packages in a very simple way (no ACK, no routing, just raw data transmitted). For the simplicity of the task...
Hi,
i am using sdk 16 , nrf52832 .Merged with two sensors , i am storing it all in an array
example
uint16_t array[7];
array[0]=67; array[1]=90; array[2]={90}; .so...
On a device that is pretty sensitive to lag (with a display and HW drivers), I observe sometimes some lags of about 100 ms.
I tried to disable some part of code to see what...
Hi,
1.I have a long-rage ( Coded PHy ) connection between a Master and a Peripheral. Master is 52840 , Peripheral is 52833 ( on battery )
We have notice that setting longer...
I want to use nrf52833 as the keyboard and nrf52820 as the dongle.Refer to the example of ncs1.3.2\nrf\applications\nrf_desktop, I want to add the LLPM of nrf52820.
But...
