Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi,
sdk ncs v2.1.2
example :mqtt_sample
1. The mqtt client connects to the server
2. The mqtt server is faulty
3. The mqtt client cannot detect the server fault...
Hello,
I've been trying to flash the NRF5340 from my M1 Mac for a few hours now. But every time I get only the above error and that I should contact Nordic if the error...
Hi Nordic,
I need BLE mesh, central mode for TAG to pair and DFU over BLE functions, can you guide me which example in NCS v2.1.2 is better to as code base?
While interfacing LIS2DH Sensor with my nRF 52832 Board, I am getting the data in x, y and z axis. But the values of x,y and z axis remains same in each reading which is not...
Hi,
I would like to set the FICR-Address as Static Device Address in hci_uart. I know how to set this address as Public Address but can't find any suitable API to set it...
Hi,
I'm using hci_uart on nRF52840DK and configured CONFIG_BT_CTLR_PRIVACY =y among other things:
The resulting .conf shows:
But when sniffing the packets...
Trying to download the nrfutil executable file from "nRF Util" page at www.nordicsemi.com/.../nRF-Util for "Linux (x86)" fails. It is expected that this downloads a binary...
Hi, I'm designing a Zigbee router based on nRF52840. I've started from the CLI example in the SDK folder but I'm not able to provide an indication if the router is connected...
Hi,
I'm working on a legacy program (Peripheral) using nRF52833 and nRF5 SDK using SoftDevice S113.
One of the requirements of my peripheral application is that it should...
Hi,
I am trying to interface nrf52840 with Arducam mini OV2640 2mp. I am trying to implement SPIM to communicate with the arducam. In the arducam OV2640 datasheet, to enable...
We are using the Fanastel BC833M (bRF52833) module in our system which uses the BLE interface to communicate with a mobile device. The device is a battery(3V coin type) operated...
Hello,
Do I have to include a DC blocking capacitor with nRF52840 if I use a PIFA antenna? Can you point me to some documentation (i.e., reference design) that would include...
I currently have an application that buffers signals by recording with an ADC on an interrupt and then retransmits the data using an external DAC through SPI. When I call...
