Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello, team.
I have some questions about reset restriction of nrf9160.
Q1. Does the restriction timer(30minutes) still run after +CFUN=0?
Q2. What is the exact meaning...
Hi guys. I read this thread answered by Einar Thorsrud. devzone.nordicsemi.com/.../direct-advertising-example
"HID mouse example uses direct advertising, but only when it...
I am using nRF52840 dongle with raspberry pi 4 to create a thread network. I downloaded nRFconnect for desktop to flash the hex files into the dongles.
I successfully flashed...
Hello Nordic support,
I understand that BLE stack is provided in nRF5 SDK as SoftDevice hex file and the flash area is fixed for the softdevice. I would like to understand...
Hi,
I'm trying to implement a circuit using a brand new nRF52840 chip. The chip has no bootloader included yet. When I try to burn bootloader, the chip is not detected by...
Hi
1. What certification is required to sell the products developed by nRF9160 in Japan?
2. What certification is required to add an antenna to nRF9160 in Japan? Do I...
Hi,
i've developed a few application using nRF5 SDK, and
Now I'm just getting started to study nRF Connect SDK (v2.x.x) by using "peripheral uart" sample.
I thought...
Hey,
Trying to compile a custom driver for an I2C device and running into issues getting the actual DT node to link with the driver at build time.
Specifically, (because...
I use Linux with the nRF52840DK. I have three such developer boards, and only the one with the serial number 1050205291 exposes two ttyACM interfaces on Linux vs the other...
Hello,
I got several questions below:
1. Once the CTRL_AP setup was already configured below, even if NVMC.ERASEALL is set , does that mean UICR registers ( NRF_UICR...
We have been looking for a standard (in Zepyhyr or SDK) way of handling communications between our software modules (drivers, modules, threads) that generate multiple streams...
Hi,
I am currently having a project which is communicating between nrf52811 and nrf9160.
I have an issue in nrf52811 when I try to check or debug in realboard.
I already...
Hi, I am currently having a project using nrf9160. I would like to learn basic of this microcontroller from example in SDK. Which pca--- should I use for nrf9160? Thank you...
I try to connect an nRF9160-DK board to a private MQTT server.
Using DNS I get a failed responce (-2)
When testing with mosquitto_pub/_sub the DNS is functional.
When...
