Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hi,
I am trying to run lightswitch example in MDK.
Provisioner keep logging : 419, Unhandled Mesh Event: 4
Button 1 is in on state.
and LD5 is keep blinking.
these...
Hello. I'd migrated my application on SDK 15.1 from 14.2. The firmware of my product is always updating so I use NRF LOG module to debug it and see what is going on in every...
Hi to all,
recently i bought PCA10059 board, but i have problem in programming it. because i had some experience with NRF51 and NRFGO, at first when received the board i...
Dear Nordic,
I am using nRF52840 chip for BLE Advertising I want to encrypt this Advertising
I Read a CCM-AES encryption in BLE is it right way to this 31 bytes advertising...
I want to sleep at the lowest current level possible while retaining RAM. I see that I(ON_RAMON_GPIOTE) is 17.37uA! I want to avoid that. I see I(ON_RAMON_GPIOTEPORT) is only...
Hello,
I just started 4 days ago. My project consists of two parts. The first module that I am working on should communicate with. a I2C sensor, go to sleep for 30 seconds...
We have an existing HCI application (SDK12.3) which implements advertising, scanning and central (8 concurrent connections). The application runs on a Linux device and communicates...
Hi,
While we perform DFU over mesh according to this in step 3: Generate a DFU file with nrfutil
we create dfu package of an application like below:
nrfutil dfu genpkg...
Hi
Over the last versions of the SDK a lot of features have been added to the log module. These new features may be useful for a few users out there, but the new features...
Following my ticket Dynamic reconfiguration of peripheral HW from TWI to SPI , I realized that the header file sdk_validation.h could be improved.
Currently the conflict...
Hello.
nrf52-quadcopter question.
nrf52-quadcopter source code download is ok in github
website bluetooth connection is ok.
joystick operation need to excharUUID(0x0004...
