Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hey there, I am using NRF52832 CIAA ( bga version)
I did some testing for internal DC DC ,
and found the following gaps
DEC1 - should be 1.3V , measured 1.27v
...
Dear support
I am developing a generic client, after connection and service discovery, there are usually a few characteristics with different uuids are found, I need to...
I'm trying to erase & write to the nRF5340 using the Programmer v3.0.0 but I get this error: Failed to load readback protection status: async task failure for id: 1198716183932...
Hello All,
I am facing an issue in nrf52840 development kit used as nrf Mesh sensor.
Issue details:
1. From the mobile application, we are setting the publish period...
Hi, I have an application that enable BLE (advertise and connectable) then disable BLE (disconnecte and stop advertising) every 10 second. My application worked when have...
Hi
I would like to include some flash in my project to store sensor readings. Please can you assist me with the SPI Flash sample and with some general questions on SPI...
May you please provide a .txt or .excel file of the location for each pin on the nRF52805 or the nRF52810.
Like the sample below for your reference. This will help us accurately...
Hi, I'm new to C, but I have made an application based on mqtt_simple that does what I want.
Now I would like to set the credentials from a variable that I have generated...
Hello,
My application stores settings in Zephyr NVS. During device production a python script running on PC sends RTT commands to write initial settings to NVS/flash.
...
I tried the tutorial at link below
h ttps://devzone.nordicsemi.com/guides/short-range-guides/b/software-development-kiti in conjunction with nRF5_SDK_17.1.0
devzone.nordicsemi...
Hi,
I have a NRF52840 and a bluetooth device. Is there a way to automate the communication by writing/reading the HEX code. It is essential for product testing. Example...
Hi
I am using FOTA DOWNLOAD to update device's application firmware. https://developer.nordicsemi.com/nRF_Connect_SDK/doc/1.9.1/nrf/libraries/networking/fota_download.html...
my net core only output the boot information and i enable config_log that uart console will put some strange info
CONFIG_LOG_DEFAULT_LEVEL=3
appcore output to ttyACM1...
