Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
HI,ALL！
I tried to add a RTC wakeup funtion to my ble device, so i add the code of the Nordic board example named "rtc_example" to my program.
But it turned out that my...
Hello,
First of all, I'm not a hw-engineer
I've 2 evaluation devices of nRF52840 (BL654-DVK) and I'm trying to test the SPI communication between them (one as master ...
I have successfully run, Nordic serialisation connectivity application on nrf52480, (And able to control this from a custom board, and also from PC). But I want to use a lighter...
Hello !
I'm currently working on a project using the DK Boards nRF52832 .
I'm disappointed that one card no longer works ( doesn't light up ). I therefore explain to you...
Hello everyone :)
I'm trying to get an analog signal from n channels. I started with modifying the battery sample from Vdd to AIN0 according to the modification - only to...
I am using Nordic Serialisation library, with a nrf52480 chip as connectivity chip and a m4 arm core custom board as Application chip. I am able to establish gap connection...
Hi,
I am trying to enable the internal clock for NRF 52832 (BMD-350) module.
The configuration option for the clock has
1. RC Oscillator
2. Crystal Oscillator
3...
Hello,
I am using the nRF52840 DK to debug my application using nRF Connect SDK v2.0.0 ..
Application runs well in debug.
But when click restart / reset .. it should...
Hi Team,
I am working on NRF52832 based on the BLE mesh protocol here I am using the Light_switch example of SDK - nrf5sdkformeshv500sr
Here I transfer boolean(0 and...
Hi, I'm developing an application based on ble_app_uart, and integrate FOTA is the last feature. I'm using sdk16, S140, nRF52833. I plan update firmware over BLE, so I have...
We've a custom board which has NRF52833 and TM52F1376-MTP-C3. They are connected over UART.
What I want is transfer binary data between Phone and nRF52 over BLE.
and then...
Hi Nordic team,
I'm going to start new BLE application project, so I tried to understand how to use nRF52 series first.
I completed the academy and I'm trying to make...
I am attempting to compile the peripheral_uart example targeting nrf52840dk, I've done quite a bit of work with zephyr but never with the nRF Connect SDK. I've encountered...
