Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi, I'm developing an application include features
ble, 2 libuartes, pwm, timer and now I'm planning add flash to my application
1. I'm using flash_fds. I find cli.c using...
hi:
I am an new user of 52840.I want make it as an ANT+ master. Then connect some riding equipment, like cardiotachometer ,speedometer , Stepped frequency counter or other...
hello,we use nRF24l01+ for the communication of IoT,nRF24l01+ need to receive CMD from the controllors,but after a long time,nRF24l01+ cannot receive data.
we have tested...
Hi,
I want to transfer a TEXT file from my android to a NRF52 unit.
Today, In my NRF52 unit i already use NUS with NRFUART application & NRFCONNECT application to send...
Hello
We have a project working on the NRF9160 dk, however we have run into some issues with our custom board, we are using the lwm2m_client sample to prevent that firmware...
Hi All,
I am trying to drive the low freq clock necessary for the softdevice on an nrf52832 (sd s132 ver 6.1.1) with the clkout signal from an i2c real-time-clock peripheral...
Hi,
We use SDK nRF5_sdk15.2 and ARM GCC cross compiler to develop application that runs on nRF52840.
We use new lib, as it was done in examples.
I noted recently that...
When I compile ncs/nrf/applications/nrf5340_audio with the latest SDK, the code repository for LC3 is required as described in the documentation. And LC3 is not open source...
Hi All,
SDK => v17.1.0
IDE => Segger
I'm using ble_app_gls and I want to remove LESC.
According to my project =>
I have define a macro,the name is LESC, it used...
I am trying to listen for bluetooth advertising packets in nRF52832 ( pinetime watch to be exact).
What is the minimum required code to program radio in pure bare environment...
Hi,
I want to use nRF connect to program the "direction_finding_connectionless_tx" in my nRF52833 but nrf connect doesn't recognize my device.
There is no error message...
Dears, I used NRF9160 and i have some questions about it: 1. the internal rtc is accurate or not ? is calibrated or need to be calibrated every time? 2. this rtc is internal...
Hi,
I use FDS to save my data in my application. Below is my fds list. All RECORD already have data from factory production.
#define FILE_ID 0x1111 #define RECORD_KEY_TORQUE_0...
