Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
I have problem with implementing UART to simple_coap_client example, but there is too much problems. Some issues have been solved, but it still is not all.
defines...
I need the nrf52 as a I2C slave, so I set up a very minimal example:
which seems to work so far. the chip wakes up, receives the i2c msg and is able to send back data...
Hello,
I'm trying to do some power optimization in my project and I'm looking for information about current consumption of different peripherals. Unfortunately, the information...
Hi,
Currently I am trying to implement Watchdog functionality into my Project.
I have the followowing problem:
I use the Nordic WatchdogTimer.h and instance the class...
I am trying to implement a DCT on a nrf52840 board and have been looking at using the CMSIS DSP DCT function to achieve this. Does anyone have an example of this function...
I have 2 custom made boards.
I took the first board.
I tested low power consumption. And it WAS working.
Made multiple tests on i2c, BLE, GPIO, Flash memory... All worked...
Dear nordic,
when i try to scan in coded phy some times works but after few minutes it fails to scan(that is not capture beacons). some times it fails from starting(that...
Hello,
I have an issue about the NRF9E5 and the external EEPROM.
When I program the external EEPROM sometimes the procedure fails. When I retry the action is impossible...
Hello,
This is Jahnavi. I am having nRF 52 DK boards. I have a doubt that what will happen if we will give power supply from both coincell as well as USB cable?
Is there...
Development environment: SDK V15.2, Soft device S140 V6.1.1
Application status: unmodified, logging level changed from INFO to DEBUG, debug-flag -DDEBUG set during compilation...
Hi,
When I try to install apps in nRF Connect v2.1.0, I get the following error " Unable to install: Unable to download registry.yarnpkg.com/nrf-framework-courses . Got...
Hello !
I got bad time figuring out how we can prevent a Malicious device to corrupt our thread Network and only allow our device to connect to this mesh network.
I am...
I am trying to get the nRF52840 to interoperate with an existing product using the Telegesis ETRX357 Zigbee radio running a Zigbee 2007 PRO stack. For now, I’m using the nRF52840...
Hi,
I'm developing an application on Android based on nRF_UART apk source, but i'm having trouble in connecting to two BLE devices. Actually, i think i could manage to connect...
