Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
I'm searching informations about the regulator REG0 (Internal regulator of the nRF52840 chip). I have find the chapter "5.3.8.2 Regulator specifications, REG0 stage...
Hello Nordic
I repost devzone.nordicsemi.com/.../peer-manage-problem
I noticed new SDK 15.3.0 so I try to change SDK from SDK 14.2.0 to SDK 15.3.0 and from s320 5.0 to...
hi,...
i am using nrf52382 and nrf52840 ... one is client and server . i am using mesh sdk 3.1 .... i have debugged the example light switch server and client respectively...
Hi,
Recently I have migrated my app of SDK13 to SDK15.2. It's a little bit complicate but it works with patience, thanks for the migration guide !
My problem now is when...
Hi,
I've just downloaded SDK 15.3 and compiled BLE peripheral HRS app. After flashing SD 332 and the app and starting it, it seems to hang on disconnection. I.e. It starts...
I developed an application using nRF5 SDK for Thread and Zigbee v2.0.0 but I'm having problems when I want to send a broadcast from the Coordinator to all Sleepy End Devices...
Hi,
I wanted to know about gps of nRF9160. How much is the accuracy of this device ?
Anybody has worked on gps feature of nRF9160 module ?
Regards,
Archana
Hi,
I need some clarification about how to differentiate the normal press and long press detect for a single button to assign awake and sleep mode.
I am using nRF52832...
Hello,
First of all, here is my setup :
- SoC : nRF52832
- Board : BLE nano v2
- SDK : 12.3.0 version
- SD_Version : s132_nRF52_3.0.0
- Compiler : GCC
- Smartphone...
I found strange slowdown in SEGGER_RTT_printf() output which I use for reporting RSSI value at t BLE_GAP_EVT_RSSI_CHANGED event.
My sample code for nRF52832 is based on...
Hello,
I am using two nrf52840 DK boards, I tried to run TWI scanner example on one of the boards of SDK 15.0 example. I'm not getting the other device address it is giving...
Hello,
I'm working on a new project I just got passed on to me, and I just realized that the project uses indications instead of notifications for no good reason.
Then...
Hi all,
I'm testing serial_uartes example (from SDK v.15.3.0) on nRF52840 in order to adapt it to my own project.
I need to receive and send large amount of data (up to...
