Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
We area working on an iOS Application using nRF Toolbox as a reference. We are currently implementing OTA DFU over BLE and are able to update the nRF52 devKit from...
Greetings,
I am trying to develop an application on the nRF5340 DK that requires me to collect data from a sensor using I2C and I am confused on how to do that. I have seen...
Dear Community,
We are working on a bike finding device that you connect with trough an app. When you are in range of the device you can press a knob on the app and it will...
Hello,
I am trying to use the HTTPS client code to make a personalized request to my server. The data returned in the post request is printed using the default buffer specified...
Hello,
i have installed seggar embedded studio in my ubuntu pc. and i have added the CMSIS wizard using
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic...
Sorry, there is an examples that explain ho to use a coded NUS . I need to increase the distance and I don't need to be "comaptible " with other ble device.
Best Regards...
Hi,
I'm using the nRF52840 using SDK 17.0.2. I've implemented the CLI for flashlog as well as several other custom commands. It works well when entering commands on the...
Hello, I am studying the subject example project to understand how to create my own characteristics and adapt the project for our application.
What is the purpose of the...
how to compile openthread library files for nrf52833,
i followed the procedure as below
start with a fresh copy of the SDK, and make sure you place it as close to the...
Hi Everybody,
We found little or no literature about readback_protection on the nRF5340 SOC. Our issue is that for development and debugging it is not practical to use nrfjprog...
I have created an application using SoftDevice S112 using board pca10056e and installed it on the nRF52840 DK. I want this application to run on the nRF52805 so I want to...
