Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am evaluating the nRF54L15 for an power sensitive application and are measuring power consumption on the BL54L15u evaluation module.
However, my measured current values...
Good day,
I am currently using NCS V3.1.1 and nrf52840 devices.
We are making use of the light control server model and a ambient lux sensor device.
I do have the following...
Hi, I would like to use TCXO as main source for HFCLK on my nRF54L15, but not sure if it will work. Please are there any specific steps I need to follow to do and how should...
Hi,
I am currently evaluating the nRF54L15 DFU single-slot sample available in NCS 3.2.1: https://github.com/nrfconnect/sdk-nrf/tree/v3.2.1/samples/dfu/single_slot
I have...
Hi Everyone,
I use Zephyr from nRF Connect SDK and I am trying to build a tf-m sample application (zephyr/samples/tfm_integration/psa_protected_storage) for non-Nordic targets...
Hi Team,
I use your nRF Cloud REST API /location/ground-fix endpoint to obtain location based on LTE cells.
According to your documentation, the „eci” parameter for...
Hello, I am evaluating the device for a new products line and trying to avoid a potential conflicts while mapping I/O's and peripherals for connections on PCB. Where I can...
I have v3.0.0 SDK currently . I am using nrf54L15DK . Do we have any sample code for checking AOA and AOD of the advertisements from the peripheral devices.
I could find...
Hello.
I'm developing a project with nRF (because of Bluetooth) and 6DOF sensor LSM6DSO. I would like to be able to configure the sensor in more precise way, e.g. like continuous...
I saw in nrf connect sdk 2.9.1 that there was nRF54L15 sample code for Channel Sounding and nRF52833 DK sample code for Direction finding.
But now I want to implement...
Hi,
I’m working on an nRF5340 using nRF Connect SDK v2.7.99-cs2 . BLE security is configured as Just Works (Security Mode 1, Level 2) on the peripheral . I want to increase...
Inquiry: NTN Support and Application Feasibility on nRF9151
I would like to seek clarification regarding Non-Terrestrial Network (NTN) support on the nRF9151 .
There have...
Hi there,
When flashing my solution to Lesson 6 Exercise 3 using nrf52DK / nrf52832 - I kept getting an access violation when attempting to setup the timer. I compared the...
