Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello All,
I am working on one of the project using nRF51822 . in this project it requires multi communication protocols i.e i want to configure as below,
2xI2C
2xUART...
I currently have 2 redbear nrf51822 nano. I want to connect the UART of the nrf51822 to my arduino uno/nano but i dont know how i should do this. I tried looking for a solution...
Hello,
I am using PCA10040 and sdk12.2.2. I am trying to load ble_app_template code. But when I try to flash my code in pca10040 I am getting error as "No Jlink Device found...
I have a nRF51-DK and SDK8+Keil5.
I also have a module that sadly uses an old revision 1 nrf51822. It is connected via SWD to my nRF51-DK.
I could programm it with keil...
Hi,
What is the use of Tacq and the sampling rate in ADCCON2 (pg 169-170 in nRF24LE1 Product Specification 1.6)?
They seem independent of the sample resolution. What...
I have a requirement that in BLE Beacon Packets, I want to send the time stamp information with in Beacon packets . My questions are : 1. Is it possible to include time stamp...
Hi All ,
I am designing a project and having some doubts here.
Basically project is about tracking actual work hours of Laborers in the construction site.
I have already...
We are designing a product that allows multiple users to connect their phones to the same peripheral device. I wanted to check it out with this example:
infocenter.nordicsemi...
can somebody tell me where to find these error codes?
error = app_twi_perform(&m_app_twi, als31300_read_sensor_transfer, 2, NULL);
APP_ERROR_CHECK(error);
perform is returning...
