Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
I am using nrf52840 and SDK 16.0.0
I have integrated two examples, ble_app_template and nrf_calendar example . Now I have a problem. I wanna update the manufacturer...
Hi
I just joined a development team for a monitoring system consisting of a master and 5 slaves. They have a prototype that works well, using the functionality of the ACK...
I am trying to read the primary services using Master Emulator API and i am getting the below error. Using the Master Control Panel (MCP), it got no problem reading back all...
Hi,
I am developing nrf52832 on zephyr platform, I have seen a very useful GitHub library you guys have created called 'NordicPlayground' https://github.com/NordicPlayground...
Hello, I want timer to interrupt if timer is not restarted in 200ms and wrote below code.
I am restarted timer in few milliseconds using below but still I m getting...
Hi，
I get news at the homepage about that Nordic announces support for Amazon Common Software for Devices.
May I know which version of SDK can support this ?
If yes...
I have been programming nRF9160 using v0.4.0 SDK and it has worked fine. However moving the same program to Nordic Thingy 91 has been giving me problems. The board nrf9160_pca20035ns...
Hi,
Creating an new app will only call the main() in the form of task, i have requirement to create couple of task in my main() so is it possible to create user defined...
Hello,
I'm trying to run Simple_mqtt code on developement board with nRF9160. Connection to LTE takes in my opinion very long time. On basic AT sample code it's connecting...
I am able to build my project, but when I try to flash it to the board via ninja flash_<target> I can select the device in nrfjprog.py, I know, that I have to use "'0'" as...
I am attempting to add a UART to interface to an external MCU. I have the uart example running (without any RTT info) yet when I port the uart code to the ble-thread example...
Is it possible or there is support in nrf52840 such that I can enable readback protection from the firmware itself?
I found an APPROTECT register in bitfields. But how to...
Hello,
I have one custom board which have Nordic's nrf52840 chip. I'm using this chip to scan the surrounding beacons.
For beacon scanning i have integrated Bluez stack...
