Has anyone converted the app note AN34 DTM Python script to C# or C/C++ ?
The Python DTM script is works OK with the setup specified in the app note AN34 figure 2, which...
Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
This is not a real question for support. It's more a success story i'd like to share with you!
Our company develops firmware for various customers on a lot of different...
Hi all,
What is the maximum data rate for the nRF24AP2 when using the Synchronous serial interface?
I cann't see it in the datasheet.
Is there anyone can answer me...
Hi All,
I have a question that i remark this code run different mode have different results
in Release mode => build success,the project can run
in Debug mode => the...
Hello.
I have couple of questions for hardware parts location on pcb with nRF9160.
Q1.
I'd like to ask a better location for eSIM(MFF2) related nRF9150.
This...
I'm trying to add a second element to (light_switch\server) (SDK_for_Mesh_v5.0.0). I've already have a look at this post , it gives an idea but I found that it's not applicable...
In an effort to fix Toolchain problems setting up nRF Connect, I uninstalled Python and tried reinstalling via choco install python as per the "Installing Manually" instructions...
Hi,
Please fix this bug: The DK device is no longer found after following the following procedure
Problem operation process emerges
windows:
DK:PCA10090 0.9...
Hello,
I started my prototyping with the 52840DK and the SD Card was working fine. However, with the 5340 dev kit, I cannot get the SPI to work and access the SD Card properly...
Hi,
I connected my nRF52840 dongle to the laptop, it was detected with a red LED glowing on and off. Later I installed the nRF Connect software and installed the Power...
In our nRF52832 application, we have an external 32.768KHz crystal as the nRF52832 low frequency clock source. We also have a 32.768KHz oscillator on the PCB that is used...
Hello,
There seems to be a bug with scanning for many Bluetooth advertisements while simultaneously sending data over uart in Nrf sdk v17.
I have tried to work around...
When loading the nRF Connect Plugin for VCS, I am receiving either a crash message or the message below. It looks like a Python syntax error in the kconfig extension. python...
SDK 17
Soft device 7.2.0
nRF52840
Started with the 'fatfs' example, updated it to allow uninit, and to not reinit the IO if init is called multiple times.
it's working...
Hello everyone, I combined work with a timer and an example from ble_app_aurt pca10040 s132, the problem is that the timer does not work evenly, yes, I know about the low...
dev environment segger embedded studio with nrf5 sdk
I have separated my project source and the paths of nfr5 sdk the project have different folders for different drivers...
I'm using led1 alisa for indication that network core is runing. But if I compile program, variable is not initiated from DTS. It looks like compiler does not init dtLed variable...
