Hey Team,
I'm trying to flash the audio application on our custom PCB, this PCB follows the interfaces of the nrf5340 audio dk. Previously on lower SDK versions (2.7-2.9...
Hi Nordic team,
This is a follow-up to my previous question here:
Can nRF52833 perform PAwR while also syncing to another PAwR device?
We are now extending our design...
Hi,
I'm trying to build nmea parser, so I have a functionc hecking all nmea sentences and trying to get double value, but I always go bad double value. For example here...
Hi
I am trying to setup and test the OpenThread CSL feature on nrf52840DK with OpenThread daemon and RCP mode nrf52840DK.
I found there is a way to build the Daemon for...
Hi,
With several nrf52840 based prototypes, I had serious problems. I could see them die after flasing them a few times. And this was not just one dying, it was all of them...
Is a common ground required when measuring current in current meter way?
Can externally supplied voltage exceed 5V? Will this cause inaccurate test results?
I'm working with nRF5340 and nRF Connect SDK 2.9.0, using sysbuild and Partition Manager for my project. I want to enable Zephyr's coredump feature and store dumps in internal...
For nrf51, the current consumption is more than 1mA when GPIOTE is used since 16MHz clock is always on. Is this fixed for nrf52? or nrf52 still has the same level current...
Migration document is great - I'd be lost without it. I'm just trying to be sure I understand the two changes for "GATT Server Authorizable Write Commands" and "GATT Server...
Hi,
My S130 based BLE implementation, when scanning, seems to receive BLE advertisements out of order, when the traffic is high. I wonder why. Could it be so that the callback...
Hi,
I would like to misuse the SDK by creating an communications systems based on advertising. From several Q&A posts, e.g. this one ), I understand that the current S130...
Hi,
I am writing an application on top of NRF51, using a S130 Softdevice. I wonder about the concurrenceness (?) of the code I write, and especially if I need to use critical...
How do I make sure, the GATT server running on the BLE peripheral client connects only to a specific app based central/GATT client app, which has been authenticated via web...
Hi everybody!
I am working on ANCS and I found a problem that: At the first time I connect my Iphone to the dev kit, the pair request appeared on the Iphone. If I ignore...
Hi,
I have been having a lot of problems communicating with an Atmel SAM D09 as a slave, and an nrf51422 as a master.
I seem to have two problems, hopefully solving...
Hi all,
I design the kb based on the SDK6.1 and SD7.1 with 51822, and doing the PTS certification now, but meet some problem on TC_CON_BV_01_C, ATT Write error, such as...
the error messages show following:
compiling system_nrf52.c...
RTE\Device\nRF52832_xxAA\system_nrf52.c(92): error: #136: struct "" has no field "A0"
RF_TEMP->A0 = NRF_FICR...
Hi guys, I use old project try to build again in Keil when I installed nRF51_SDK_8.0.0. But I get the:
.\Objects\ble_knob_detection.axf:
Error: L6200E: Symbol
GPIOTE_IRQHandler...
Hi guys,
Has anyone encountered following warning message when using nRF51 SDK v8.1.0 or 9.0.0 and compiling project by GCC arm-none-eabi (I'm on V4.9 2015q2 which is the...
