Hi everyone,
Currently, I am working on my bachelor thesis for creating simple network by using MQTT, BLE-6LoWPAN and nRF52832. I have three nodes of 52832 and one raspberry...
Hello everyone!
I want to form an Openthread network with three Nordic nRF52840 cardboards. I would like to monitor the traffic using a sniffer, but i can't receive any...
We are using the development board PCA10040 for implementing a prototype with several GPIO interruptions.
We are trying to use the NFC pins (pin 9 and 10) as pins of GPIO...
Development Software:
nRF5 SDK for Mesh v3.1.0
SEGGER Embedded Studio for ARM v3.50
SoftDevice S140 v6.1.0
Computer Platform:
Windows 10 Professional
Hardware...
Dear,
software/hardware:
nrf52832 mesh sdk v3.1.0
Q1: when friend feature node code can get? now just is bin file.
Q2: mesh has just four feature devices, friend feature...
It seems the LTE-M / NB IoT isn't available Europe-wide yet, and roaming applies country-wise.
Can anybody share his/her experience of using the BLG840F?
thank you.
Hello, this is a continuation from a different question I previously had answered: https://devzone.nordicsemi.com/f/nordic-q-a/40452/nrf24l01-spi-communication-with-nrf52...
Hi Sir/Miss,
I use below items to develop:
HW : PCA10040 (nRF52832)
SDK: 15.2
Softdevice : s132
IDE : SES V3.40
After I create my task (two same priority tasks...
Hello,
I am trying to measure the current of the dk. I added the 10o resistor, loaded the ble blinky example and connected two probes. This is what i got:
In the idle...
Hi Nordic,
we started with the light_switch example
and created a second onoff model to it -> system compiles but runs into error
also tried adding a other generic model...
Hi All.
In custom report descriptor I try to use this code:
ret_code is NRF_SUCCESS
but on host while reading feature report I don't se a changed value. Maybe I'm...
Hi,
If an ESB PRX has queued a 250-byte auto-ack payload, that will take around 2ms at 1Mbs to transmit.
If the ESB PTX has the standard 250us repeat interval, will the...
I am confused about the value of RX_PW_Px register what will be the value of this register if more than 1 dynamic payload packet arrives on the same pipe-x.
I'm a beginner I'm having hard time understanding UART. In my opinion, the documentation is going too straight to the technical details and tutorials without even starting...
Dear friends,
Is there any ideas for measuring the distance between a BLE module and a beacon module without using RSSI?
With Regards,
Sunil
Calixto Systems
hi..........
i have developed nRF52832 QFAA using your schematics,and i have added sensor to it . Now i can able to flash the code and ran successful but i can't able to...
Hi,
We are developping a system connected to several devices based on NR52 MCU.
The DFU works with the nRF connect application.
Now, we would like to update the device...
Hi,
I am just getting started with the thingy 52 and I need some guidance. I am a EE by profession so I feel a bit out of my league here.
When I unwrapped my thingy I...
Hi there,
I am adding security to my service characteristic and i found that for security mode 1 level 4, bonding is required in order to access characteristic values. Is...
Hello,
My problem is pretty much identical to this one:
devzone.nordicsemi.com/.../
My functions look exactly like the ones posted in the original question and I...
