Software and Softdevice: SDK 12.3.0 keil5
Platform: Windows 10
Hardware: NRF52832 DK
I am trying to combine WDT and FATfs together. But once I have both of them, there...
I am trying to get a good handle on the difference in average power consumption between BLE point to point and Zigbee on an nRF52840. We have battery powered products and...
Hi, For my project, I need to design a BLE packet sniffer which scanning the 40 channels. Therefore, I need 40 dongles are connected to a computer that can read and transfer...
I am writing code to get a nrf52840 DK to associate with an existing 802.15.4 coordinator using the 802.15.4 API module within SDK 15.2.
I've called "mlme_scan_req" and...
Currently, I am able to use Mqtt Publisher or Subscriber with only one Nrf52 device. I can ping to the device with link-local address.
I am using Nrf52832 with SoftDevice...
Hi everyone,
After days of figuring out how CMake works, I try to write a CMakeList.txt myself, and decide to put my progress on this community. Right now, using CLion with...
i am using nrf 52832, i got SAADC example code from sdk. that code done by using timer. i could not understand timer section. Is available SAADC simple example code without...
Hi everyone, i am new at this platform.
In my project, i need to take gps data from uart and send the data over zigbee with nrf52833. I haven't found any example and don...
Hi All, trying to find a cause of this problem, we have two devices, one is acting as peripheral and one as master.
Peripheral: ( nRF52832, s132 v7.0.1) a remote wireless...
I am trying to make a build with a slightly modified copy of the Zephyr button example on a nrf9160 board with a upgradable bootloader.
The following command can build our...
I seem to get error 4 on nrf_sdh_ble_enable when building and running the application in release mode.
Everything works perfectly when building in debug mode and I've checked...
Dear Ladies and Gentleman
Regarding the Bluetooth SIG Qualification the BQC needs a QDID for the Softdevice Controller Subsystem ( from table 2 of the compatibility matrix...
when i debug samples in Zephyr, i can see log through UART when i use "printk" function.
but i find there has "BT_DBG" and "BT_WARN" in code. so what's its using? and where...
i am receiving some packets so i need to send that packet to central device(mobile) if i send 20-20bytes it successfully sending the data to central device(mobile) if its...
Hi, i am new at nordic. I am working with nRF connect sdk. I am trying to run example applications but the code never runs. I have checked with debug and it never goes to...
I'm using NRF Connect SDK 2.1.0 and a 52840DK. In normal (non-bootloader) mode bluetooth initializes fine (bt_enable succeeds). However, when I start using MCUBoot, bt_enable...
We are experiencing connection issues for specific Android & iPhone but not for others (i.e. Samsung Galaxy S9).
Phones with issues
Android Details
Samsung Galaxy...
Dear,
I have 2 kits nRF52-DK and nRF52840-DK. I want to make simple app for sending data from one kit to another. Is it possible to use only the radio without using BLE...
Hello guys, i currently applying the example about MPU9255 following this: GitHub - Martinsbl/nrf5-mpu-examples
i'm using the app_mpu.c, app_mpu.h, mpu9255_register_map...
Hello,
Just starting off with Nordic hardware and have some basic questions, first my setup:
nrf52840-dk development board
nRF Connect v2.1.0 SDK
Setup to use 2...
