Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
hi all,
I am using the following example:
"..\nRF5_SDK_12.3.0_d7731ad\examples\ble_peripheral\ble_app_uart_adc_scan_mode" to send via bluetooth data coming from ADC. ...
Hello, team.
Thank you for helping.
I was wondering that what is the difference between 'managed flooding' and 'relaying' in mesh.
The only one that I know is provisioning...
Hi,
I am just a beginner in this field and need support to proceed.
I want to have a BLE Mesh network using lights, switch and occupancy sensor. In this I want to use...
Hi,
I need to modify the ble_central_hr_c example to connect to the hear rate strap with the best rssi.
For this I got to say listen for 10 seconds or so to all the...
HI,
I want to update the application FW in mesh sdk environment from flash memory. The new binary is in the flash memory already (I received it from a spi-ethernet interface...
Hello,
I am working on the nrf52832 board. I am using the NUS example as the base.
For my application i need to send encrypted data from the phone i.e central to the board...
Hi
Tring to setup development environment using nRF Connect for Desktop ( nrfconnectsetup342ia32.exe), in Windows 7 host.
Used tool manager to complete all necessary necessary...
Hi,
we are using both system on and system off power mode in one of our application.
Sytem on : wakeup through RTC for an every 60 seconds once / GPIO.
System Off :...
Using nrf_mesh_sdk_4.0 and ble_sdk_16.0:
1.I want to load light_switch_server code on nrf_dongle.
2.And then take data from r-pi through usb of dongle and publish it over...
We have been using the nrf9160 successfully for several month. I'm currently upgrading our products to use the new modem firmware (1.2.0) and, together with that, to the most...
Dear All, I wonder if there is a way to empty a work-queue that has work items pending. Is there a way to empty the whole queue or is there a way to remove individual tasks...
hello Nordic
i added a watch dog to my code
i try to create an error by putting a breakpoint in the code (though i actually didn't start the ble scan which usually...
Is there an analog to the `BleManagerCallbacks.onLinkLossOccurred` method where I can receive a notification of when a central re-connects to its peripheral?
