Hi all,
I've developed a broadband vibration energy harvester that is able to pick up uW of energy from just a couple Hz all the way to 150Hz. I'm currently looking for...
We use SDK12.10 Main.c (d:\nordic\5142xx\software\org-sdk12.1\nrf5_sdk_12.1.0_0d23e2a\examples\ble_central_and_peripheral\experimental\ble_app_hrs_rscs_relay.
My question...
Solved: Well, turns out delay and SCK doesnt work well together haha. I imagined the sck signal to be a background thread of some sort. I was wrong.
Hi guys,
at the...
Hi
Im looking for a developer in Denmark to discuss ble technology with. Im trying to get better to understand the technology, because i have some ideas involving beacons...
This system does not work if I enable the third Pipe (Pipe2) .
The system is working without any problem as one RX and two TX (Pipe0 and Pipe1).
The problem on enabling...
Hello,
i have read if not all posts about writing to FLASH while using BLE. But could not find the desirable method.
What i would like to do is to write to flash from...
Hello,
i have read all posts about writing to FLASH when using BLE. But could not find the desirable method.
What i would like to do is to write to flash from characteristic...
Hi,
I have a particular use case and have been thinking different ways to implement it.
Let's say there are different beacon sensors (static/moving) installed in a big...
Hi,
Based on Matter samples provided, OnOff cluster is working great (using nRF5340).
We shall implement a more complex (and custom) cluster with 30 or 40 items and send...
so this is something weird I encountered.
Every time I use an eraseall statement and download my firmware, the chip doesnt start up immediately unless I reset it 4 times...
Hi,
I am completly new in nrf-connect sdk and zephyr environment.
i don't understand how to configure the Eddystone TLM format for the nrf5340dk. I tried wiith the eddystone...
I am having trouble getting the data (7 ASCII characters) transmitted via UART using the interrupt driven mode. The uart_fifo_fill function returns a positive number (the...
Hello,
I was developing an application and was using the ble glucose application as a template. This uses the s140 softdevice, however as I am using the nRF52811 in peripheral...
Hi,
As queried before in this link , I am not able to restore the model publication state after reboot. Am using sensor server example to write my application on top of...
Hi,
Because I am not getting any answers to my original ticket(ID: 294922), I'll try it this way by opening another ticket on the same issue.
I have a nrf9160DK and flashed...
Kind folks,
Situation: The product page for the Thread Topology Monitor v1.3.0 lists the following compatible dev kits (to which I've added the PCA numbers):
nRF52840...
Hi, is it posibile for use nrf21540 in the other brand BLE MCU board? some custmer maybe do not want use Nordic BLE, but want use nrf21540+other brand BLE, it is posible to...
hello!
I want to use Jlink to download code to a NRF52840 chip as MCU development board, but the number of pins and pin spacing of my Jlink are different from it. So I had...
Hi, Nordic support,
I have built success with the example "nrf5340_audio" set the gateway mode. when I run the example into my board "NRF5340 Audio DK" I get this error...
Hi,
I'm trying to use the nRF9160-DK(Ver.1.0.0) for LTE communication and GPS location information acquisition.
I found a list of LTE antennas at this URL. However, I...
