I am working on a project using a ble nano (nrf51822) using the Nordic SDK 8.1. In the examples I found a way to control an LED using the methods LEDS_ON and LEDS_OFF. I wanted...
Hello,
I am using ble_app_gls example and I have implemented static passkey in the code. Now I want to see if wireshark shows the passkey when I connect to ble devices. For...
Hi Team,
We are implementing an UART communication between a M4 processor (UART master) and a nRF51 (UART slave) and we want to use the UART in Low Power mode with flow...
Hello everybody,
for my project, i will bond the peripherial with the central.
I test my device with the MCP and can connect without problems. When i press the Bond Button...
Hi all,
I am trying to count the positive edges of a 3.5MHz signal with GPIOTE, PPI and the TIMER1. Unfortunately i can only measure to frequencies up to a little more...
Loaded Softdevice S140, ( Using NRF52840 DK board ) using NRFgo Studio.
App flash base is set to 0x00021000 and app RAM base is set to 0x20003000
Looking at the CPU...
In our earlier projects with nRF51 and SDK 8 we used to have bluetooth device names of length 13 or 14 characters. However, when using nRF52 and SDK 12 I noticed that the...
Using the debugger in SEGGER Embedded Studio and two nRF52-SDK circuit boards, I am stepping through code from the nRF5_SDK_17.0.2 examples.
Very often I end up in file...
Hello everybody,
I'm working on a Project with nrf52dk(nrf52832), and sdk 15.0.0 where I need to read the data from multiple sensors with twi/i2c and send the data via ble...
Hi,
is there a possibility to check in waht CE-level (ECL0- ECL2) the modem is operating on? I know that the ECL is decided by the network and not the UE. However it must...
Hi, I have a problem with simultaneously working Bluetooth LE with LTE. I've use nRF52832 as a Bluetooth controller with is connected to nRF9160 via Low Power UART HCI. When...
Hello I have a few issues which i can't handle. Platform: Visual Studio Code on Windows 10 Board: nrf52840 dk
In my project i need to create workspace which few different...
Dear N ordic S upport Team,
After I updated the nRF Connect SDK (1.5.1 to 1.6.1) and the Modem firmware (1.2.3 to 1.3.0) on my nrf9160 DK device (v1.0.0, SiP revision 2...
I want to use the nRF52840 in the High voltage mode. In this mode as per my understanding, both regulator stages needs to be used. As per the datasheet, configurations given...
Hi all,
I want to update my application with the newer NCS 1.7.0 version. I've changed my west.yml, which containing only NCS-SDK as the only dependency. After running...
Hi,
I would like to setup vscode to develop nrf applications. However, I'm having a problem for the installation of the nRF connect SDK in ubuntu 21.04 (Hirsute Hippo)....
Hi，
Our products encountered some problems when doing air upgrades.
chip: nRF52832
sdk: 17.0.2
The picture above is the switch circuit part of our schematic...
Hi, I'm using nRF52832 ble_app_uart example project. In ble_gap.h file, I could see:
From my understanding, the number 4 means that the variable sm (security mode) will...
