hello
i am using the Nrf52dk with Visualgdb.
i try to run the example project (tcp/IP -> client).
i am using the Nrf5 IoT sdk v0.9
Project complied successfully but i...
I'm using an nRF52 (SDK11.0.0, s132) and am able to generate a hex and axf via Keil/uVision. It uploads and works just fine using a Segger J-Link. I want to try some lower...
Hi, I'm a newbie to Nordic and need to use multiple nRF24LE1s to get ADC values and transmit them to a single nRF24L01 connected to an Arduino. I need sample Keil compiler...
HI:
i hava a sender and it send a frame every 15ms ,not use any protocol,and reciver code like as follow:
while (1) {
Rf_StartRx(ReciverSC.RfBufPointer...
Hi to everyone,
i have an mb39c811-evsk-02 and over it there is a tmp102 temperature sensor and an nrf51822.
I want to read the values of the sensor over a beacon app. ...
I'm having issues trying to program a custom board with NRF52832_QFAB in DC/DC config. I couldn't reach a complete programming getting error in open ocd with two programmers...
I'm looking for the NRF52840 hardware reference designs. Most of the links I saw seems broken. I'm particularly interested on the minimum components used as I'm looking at...
i am testing nrf power consumption using amper testing method and example which i am using was ble_app_uart. i modified the example by adding app_timer and removed sleep,...
i want to sample 2 ADC channels value and send to smartphone, and my thought is use the software time to sample 2 ADC channels every 500ms, the code is like this below. void...
Hi,
I am trying to toggle an LED in bootloader, adding nrf_gpio_cfg_output/write has no effect to the code. The code compiles without errors but doesnt seem to be executed...
So I have been using your chipsets for a little while now and love using Nordic products. The GPIO are super easy to use with your drivers and there isn't 18 million sleep...
Hi,
I want to make a bluetooth mesh system with over 400 bluetooth devices. As I know the Nrf52840 Dongle can connect to 20 devices concurrently, so if I use 20 Nrf52840...
Hi
Am trying to establish nrf52 DK as peripheral with nRF connect application as central but am unable to establish connection between both.
Please debug the following...
I've been using the CLI and also piping NRF_Log thru the same backend. In my application there are alot of time critical operations. I've noticed with some GPIO toggling for...
We have a device with firmware based on 14.2 (with sd-id 0x96) and we're trying to do a DFU over BLE to a firmware base on 15.2 (with sd-id 0xAE).
We can do a firmware update...
Hello:
I've got a application where I want to detect if the NRF52 is near a NFC reader. I don't need two way communications, but it would be good if the reader could modulate...
OK - so I just started with these chips, and have been asked to find out why SWO debug signal is getting corrupted.
At fairly random intervals the signal passive state inverts...
Hi,
I'm having problems connecting to my device, because whenever I do so, the SoftDevice asserts at address 0x12CFA.
I use softdevice S140 v6.0.0 and SDK v15.0.0.
I...
SAADC can't measure input voltage higher than VDD voltage. External battery (18650) voltage is higher than on-board VDD. There is very good article on your site explaining...
