Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi first: thank you for your precious support.
second: I do not need an answer I will avoid the problem I describe below
third: I'm definitely not an expert don't trust...
Hi Nordic Team,
I am working on a custom nRF54L15 board using NCS, and I would like to use an SPI-mode SD NAND Flash (LGA8/SOP8 package, SD 2.0/SDHC compatible, SPI interface...
The example layouts for the nRF7002 CEAA make use of microvias for escape routing, which makes sense. However, those microvias are also used to connect the ground associated...
When running the modems gnss in single shot mode with external 600 second interval timer and periodic mode with the same 600 second interval, what differences are there in...
Hi,
I've just updated the nRF Connect for VS Code extension to version 2026.9.2823 (September 2026 update), and I noticed that the list of compatible boards is no longer...
I want to program BTN1. For this I used the definition sw0 of nrf54l15 but that doesn't work (SW crash). What overlay structure should be used?
AI suggested the overlay...
Hi,
Can MCUboot be used as a second stage bootloader (an application from the Secure DFU Bootloader over Serial Link standpoint) to be DFU'ed to existing devices which now...
This should be simple. Where do I add my webhook to NRF cloud? I have a physical device and the events from the device are showing up in NRFCloud. However, when I add the...
Hi,
just got my PPK2 and noticed some strange behavior:
the only thing connected is USB data/power, no DUT. Power output is off. If you start logging it displays some...
We are seeing LTE-M communication dropouts on the nRF9160 with firmware 1.3.6 This has occurred several times with multiple devices. The devices are registered on the same...
NCS: 3.4.0 Chip: nRF54L15 Hello, in the past months, there has been quite a change regarding Security and Vulnerability Monitoring on the Nordic Semiconductors side. I got...
Hi,
We had connectivity issues on our end for the Message Routing Service webhook since May 13, 2026. It has been restored and tested with the nRF Cloud verification test...
Hello:
Hello Nordic Support,
We are developing a battery-powered product based on the nPM2100 and nRF54L15 , powered by either a CR2032 or CR2450 primary coin-cell battery...
