Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
Hi, I'm pretty new to microcontroller programming so please correct my wrongs.
I'm using the Libuarte driver library to have the pca10040 talk to my server via serial connection...
Hello,
Fllow the guide of Configuring and performing DFU over Mesh,I can update firmwre successful use DFU:
Source: Example/Dfu
Target: Blinky(about 180 segment)
But...
Hi i was wondering how could i send, with a coap response, one's device network name and a, for exaple a temperature value, like this:
<device's network name>: <temperature...
Hi,
I'm using SEGGER Embedded Studio to write code that writes BLE characteristics to flash storage (via FDS) when they're changed. When the device starts up after a reset...
Hiya,
I was recently looking into using libuarte (alongside SD related functionality) and while trying to pump as much data as I could over UART noticed some missing bytes...
Hi,
I am using the nRF9160 with a multi IMSI SIM card in the US. The SIM supports the 3 major cell operators in the US. I have a case where the modem registers to a network...
Hi:
May I ask 2 questions about LLPM's protocol.
1. BLE have 3types : 1M 、2M and BLE coded 。 During the application of LLPM in nRF52xxx chip, which type do you use, and...
Hi everyone,
I use the UARTE to receive data, and I want to clear rx buffer every time, because If not when the buffer will be full , the next data I received will be split...
Hello,
I'm in the process of migrating from arduino to SES IDE(For more practicality and functionality now what I'm trying to achieve is saving time by not having to rewrite...
Does the s140 softdevice use heap? If not, is it safe to set __HEAP_SIZE makefile variable to 0 ?
(as it is stated for s132 softdevice in the following post softdevice...
Hi,
I am currently using the nRf52832 for ble development in our project. Currently we are facing issues with the service changed characteristic in between firmware upgrades...
Hello,
I am working with a sensor that requires i2c(twim) communication with the sensor and was wondering if there are any good i2c examples using the zephyr drivers to...
Hello,
I am new to the nordic family. I am trying to bring up the UART1 in 9160 DK but it's not working. The same code works for UART0 appropriately.
And the code...
Hi, Our company is considering to seup a linux gateway to support BLE mesh/Thread/Zigbee with nRF52840. We want to use the binary file from Nordic directly which could support...
Hi,
I've got a custom board with an ENC424J600 connected to an nRF52840. I started with nRF Connect v2.0.0 but I've since upgraded to the latest (v2.3.0-rc1) to see if it...