Hello,
I am writing an iOS code using Swift3 to connect an iOS10 device to nRF52 pca10040 and blink an LED. The nRFConnect on iOS can easily connect using the device name...
void in_pin_handler (nrf_drv_gpiote_pin_t pin, nrf_gpiote_polarity_t action)
{
nrf_drv_gpiote_out_toggle(PIN_OUT);
}
This function work with interupt event (push...
here I have a very strange problem. I m trying to send the data(1 byte) from slave to master,and I have to use the multilink demo because I will have 2 slave devices.
The...
I'd like to erase all the pages managed by FDS as part of a "Hard Reset" operation. fds.c has a hint of a "FRESH_INSTALL" directive (part of an enum defined in fds_internal_defs...
nrf51822
SDK v10
SD S110 v8
hello!
My pj is about ANCS+nus+hid mouse sevices.
If my borad had bonded with an iPhone,then download new hex from mdk ,and run.
...
Hello.
I would like to develop FW for the nRF52832, using Eclipse IDE + ARM GCC + Segger JLink OB.
I've seen on the segger webpage that the nRF52832 is a Cortex M4 processor...
When using app_timer through scheduler, a break and go will overflow the event queue if a timer is a repeat timer. The effect is that it's not possible to debug.
To work...
Hello,
We are looking for the ways using which we can program the nrf52840 SoC without using PDK. We want to set up an automatic programming jig and for that using the PDK...
Hi,
I'm trying to setup my nRF52832 to advertise using a RESOLVABLE RANDOM PRIVATE address and to obtain this I have used the sd_ble_gap_privacy_set() before starting advertising...
Hello,
I was able to build the example project MPU6050 from Github with SDK 16. However, I used Putty to connect to the board (PCA10056) with baudrate of 115200 on COM3...
Hi, I am using nrf52832 with SDK 15.2.0 and nrf 52 dev board. I want change advertising interval in run time so I call a function with the interval as the parameter change_adv_interval...
Hi
I am using nRF52832 for my application. I need RTC functionality for counting seconds,minutes, hours and days to include timestamp for my data packets.
Can the RTC...
HI.
I Want DFU In Application So I Want to Write DFU Data In Internal Flash. Device configure has total 3 links... 2 -Pheriphiral Link and 1 Central Link use in my project...
Hello,
I am trying to decrease current consumption as much as possible. I am using ble_app_uart example, sdk 16.0.0, s112 v7.0.1, nrf52810. when I edit
to
...
Hi.
We have developed custom device based on nRF9160 and we are facing a some problems related with GPS fixing. Sometimes it takes hours to fix, even we are getting signal...
Hi,
I have blocking TWI operation in app_timer callback to read fifo from accelerometer. It works just fine but I want to make it non-blocking to decrease current consumption...
Goodmorning,
we are looking for a development kit to test the transmission for the following purpose. We need a system with one receiver and some transmitters (up to 5)...
Hi
I want to share how quickly start developing for NRF9160 with CLion, just in case someone tried and struggled, or someone really annoyed with Segger development experience...
Hi,
I am using nRF52 as a twi mater to read some data from a touch sensor, I want to perform below operation:
twi start
twi rx register_a for few bytes
repeated...
