I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
I want to build nrftoolbox app in android studio. I downloaded the zip file from the github website and also the required dfu library. I unzipped both the files in a folder...
Hi Nordic
Asking this question to Nordic AI (right-down window), below was the answer.
The nRF9160 is a cellular IoT device, and its MTU size depends on the protocol...
I am programming a RAK4631 Board, which is of course based on the nrf52840 SoC. The BaseLine Device tree has no detail in the ADC Node so I have created an overlay. The RAK4631...
Toolchain v2.70, SDK v2.7.0, VS Code, Windows
The design has an eSIM and a regular SIM, with a switch driven by a GPIO line. We default to the regular SIM, but if the library...
Hello,
How can I check which crystal oscillator is configured for the nRF52832 DK from the firmware side? Is there a specific configuration file or parameter that defines...
Hello,
I have a Python script that analyses some sensor data. If a condition is met I want to send a trigger via ESB to a peripheral board (ESB chosen for its low latency...
Hello, I'm having issues when building the peripheral_nfc_pairing and central_nfc_pairing samples from ncs 2.2.0 in VSCode. I've build before and haven't gotten any errors...
Hi,
I’m currently working on a Zephyr project using the nRF Connect SDK, and I am looking for a way to setup the toolchain for my terminal emulator (specifically using zsh...
Hi
I'm new on zephyr and nRF9160.
In the nrfx source are lots of NRFX_ASSERT() macros.
This macro checks a condition and thrown a exception.
Normaly we use asserts...
Hello everyone,
We are using the NUS service to transmit some data. To comply with certain CEM tests and regulations, we need the ability to configure BLE to publish on...
Hi,
I'm working with the nRF21540 Development Bundle (DB) , which includes the nRF21540 DK and nRF21540 EK . I need to use the FEM module with the GPIO+SPI interface to...
As title says, I have a clean install of Xubuntu 23.10, latest nrfutil and toolchain-manager package
My shell is zsh, however "nrfutil toolchain-manager launch --shell zsh...
Hello, I'm trying to get FOTA over BLE (SoC & external Flash) working on NCS 2.9.0. The sysbuild and MCUboot configurations and overlays seem to be fine. The application builds...
Hi,
I've started working with the nRF52-DK for developing a new product based on the nRF52832. I'll be using custom services so I took as a starting point the projects provided...
