Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
I use ble_app_uart_c.
I have a central(nRF52DK). I have a peripheral(nRF52DK). When i run my code, I would like to see my peripheral's name and it's UUID on the terminal...
I am using SDK 16.0.0, Soft Device S132 (v7.0.1) on a custom nRF52832 board.
I have a secure boot loader on board that is triggered by a buttonless OTA application.
After...
Hello. I'm in the midst of purchasing a power profiler to works with nRF51 Development kit and nRF51 USB Development Dongle. May I know if all the technical resources on nRF6707...
Hi there!
I am using the bluetooth/peripheral_hr sample as a basis for my application, on top of which I need to include the nrfx_qspi driver. However, I get a "undefined...
I wasted a day with this issue. I could not understand why app_timer_cnt_get() was giving me garbage on the nRF51 DK when running normally but when stepping through the debugger...
Hi, all.
I would like to assign location address for some global buffers or variables in ram by using __attribute__ keyword. And I have to add my section in flash_placement...
Hi,
I want to send data in JSON format to android app. I used ble_app_template and midi_service template to create my own service. I can send data binary as much as I...
I am new to BT full stop, especially mating it to iOS. As I see it, my idea is quite simple, but I know I need to start with the hardware, then I can get an app coded to it...
Hi,
What all the parameters should store in non volatile memory for BLE operations?. Does specification mandates some parameters should load in controller?. What are different...
Based on documentation included in http://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/ug_nrf52.html#fota-upgrades I am attempting to get DFU working on the following...
I've got several problems but they are all linked more or less with the power profiler.
All devices I have are nRF52840 dk. The code is written with Zephyr but I doubt it...
Hi Everyone We are using nrf52840 for our custom PCB along with QSPI memory. We are using W25Q128FV as our qspi memory chip.
This function mentioned below is used to initlaize...
Hi,
I want to read and write the data from IS25LP064A NOR flash with QSPI. I am using the QSPI example from SDK v16. Please let me know how to get started with QSPI in order...
