Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
Hello Nordic,
I am having an issue with the SPIM, i wanted to eliminate all unnecessary files so I started a project from Zero (Segger: new project: A cc++ solution for...
Hi,
Our application sends data to android phones with the help of OTG cables. We are using https://github.com/hariharan-m/Arduino-Android-USB this library in android for...
Hi All,
I have transferred an init packet and now prepare to transfer a firmware image.
Both central master and peripheral are nrf52840.
However, I have two questions...
Hi all,
I have been learning and doing research trying to estimate the range of a bluetooth chip. So far I've got to use Friis Transmission Equation to estimate the distance...
Hi, dear all:
I’m trying to use usbd_msc example(nrf 52840 DK/sdk 17.0.2 ) and written a string A (8 bytes) into a .txt file；
Now I want write the same file another string...
Hi,
I've recently added BT to my application and switched from S210 to S310 Softdevice. My Ant+ part is based on the HR RX example in SDK10. My BT part is basically copied...
Hello Everyone, I am generating firmware hash using an hash function provided by an external library and using CODE_START and CODE_SIZE macros in app_util.h , So i wanted...
Hi,
We are currently testing the zigbee_light example for nrf52840dk. Once in the debug stage, if we pause program execution and then resume it we find out that codes gets...
Windows 10
nrfjprog version 10.10.0
jlink mini - connected to Windows 10 USB port, try to run any nrfjprog command and it says there is no debugger connected to PC.
...
EDIT: I incorrectly reported the Secure Bootloader pca10040_s132_ble_debug .hex file included in SDK 16.0.0 wrote to addresses in the mbr_params_page, I have since identified...
Hi,
I am using ncs 1.5.0 and modem firmware version 1.2.3.
if I keep CONFIG_HEAP_MEM_POOL_SIZE=8192 then my application runs without any issue but
If I set CONFIG_HEAP_MEM_POOL_SIZE...
Hello,
We are implementing NFC functionality on our product. Specifically we're using the Type 4 Tag (Read/Write). Are there any compatible NFC reader/writer modules? I...
In my product I use certain GPIO pins configured as input with the pull up activated to act as sense inputs connected to momentary switches to control the application firmware...
Hi all
I have developed a project on the nRF51-DK board based on the proprietary RF protocol.
Now I have a custom PCB board always with an nRF51822 but only equipped with...
