Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
Was sd_ble_gatts_value_get changed from s 110 to s 132?
Please tell me how it changed.
sd_ble_gatts_value_get(uint16_t conn_handle, uint16_t handle, ble_gatts_value_t...
Hi team,
I have nRF51822 DK SMA connector module(PCA10005) and j-link lite cortexm-9 JTAG/SWD emulator.can u please tell which sdk version are used for this modules.is...
hello
i am using redbear lab's ble nano with nrf nrf51822 chipset in it. now i need to permanently store some data like sensor values and mac address of central devices...
I'm not able to find an older legacy version of Softdevice S110, specifically 7.2.0.
In the SDK Version 7.2.0 obtained from:
developer.nordicsemi.com/.../
there is...
Hello
I want to establish the connection between nrf51822(base station) and:
the second nrf51822(transceiver)
android smartphone(transceiver)
It has to be possible...
Could someone offer some guidance in how it is possible to keep the radio within IDLE mode between transmissions when operating in ESB mode? I have a sequence of transmissions...
Hi
I'm doing some S/W based on nRF51822_xxAC. I want to split RAM into 2 regions, as following:
+-------------+ 0x20008000
|__ __ _ __ |
|APP ZONE2 |
+-------...
hello, I'm trying to read the status register but all I am receiving is 1111 1111, I tried to change the code to read RX_ADDR_P0, but I also receive 1111 1111. can you tell...
It suggests that it holds the permission regarding whether a chara. can be read, but isn't that kinda redundant since there are tons of other similar properties out there...
Hello
Can i program an nRF52 chip using nRF51 DK. I plan to take advantage of the features of nRF52 including higher memory, storage and the NFC
Thanks
Hi,
My company has been running into an issue with the NRF51822 where the MCU appears to enter debug mode unexpectedly and I wanted to see if any others had experienced...
