We are using nRF51822 for our products.
We want to know the min value of "Receiver sensitivity" when we use this chip for BLE.
The Datasheet says "Receiver sensitivity...
Dear
The BLE Multi-link example (ble_app_multilink_central and ble_app_multilink_peripheral)
shows how one central device can connect to multiple peripheral devices. ...
In the MCP app, if I have the following service data for an Eddystone beacon:
0x10, // Eddystone-URL type
0x00, // TX power in dBm. This is a signed integer so 0xEE ...
I have the nRF Control Panel Android application. It works fine with several BLE devices, but specifically for the Fitbit Flex, it fails to connect.
I know Fitbit wristbandes...
Hi,
The situation:
I was able to successfully receive known packets from a device running gzp_device_dynamic_pairing, from, the host running the gzp_host_dynamic_pairing...
Hi everyone
nrf51822,softdevice s130 2.0.0
now i used softdevice s130 establish two connection as a central with two s110 peripheral device,at the same time i establish...
Hi,
I have a nrf5340dk configured as a NUS peripheral, it collects some sensor data, packs it into a 138 byte buffer and sends it to the central.
On the central side...
Hello,
I want to compare the RTC's counter_get_value() ticks with the internal clocks k_uptime_ticks() ticks. The problem is when the RTC is connected with our nrf 52840...
Hello,
While programming my board with a merged.hex I sometimes see some differences at the end of the Programmer log.
Sometimes the log ends like this,
2022-03-25T14...
Hello guys,
I am having problems on addressing an issue with my firmware. Maybe someone can assist me to find out the root cause for this, because I don't understand too...
Hello,
We buy nRF52832 chips and use them integrated on our own PCBs.
Our devices are small BLE devices to which your phone, computer, anything can connect to.
They...
Hi，
Would you provide the software of NRF52832 ESB communication with NRF24L01 ? And share the two Demo Boards PN for NRF52832 and NRF24L01. Plan to buy the DEMOs.
...
i study in derection of DOA.I now can get the iq sample from my Putty in COM PORT.i use NCS 1.9.1.I build and flash in my two boards with nrf52833.i use the cammand line tool...
Hi,
We came close to occupying all available flash memory in the nRF52833 board:
Memory region Used Size Region Size %age Used FLASH: 185620 B 187904 B 98.78% SRAM:...
Hello,
I have some issues with activating the gps-module for the "second-time" through mqtt.
See uart logging below.
First GPS attempt works, socket is created successfully...
Hi,
I was thinking of buying a Power Profiler II, but was wondering if it is possible for the profiler to measure the consumption of the chip itself or does it measure...
Controller- MDBT40 (nrf51822 based)
Softdevice - S110
I have an application where data comes from UART and have to send over BLE simultaneously. When I initialize the...
Hi there,
I have a problem to implement the SPIM in the Network core. I cannot detect any signal from SPI_SCK & SPI_MOSI by oscilloscope and logic analyzer (no signal from...
Hi,
I'm using VS Code to develop an application based on the Zephyr iso_broadcast sample.
How do you edit prj.conf? If I select prj.conf in the Explorer pane, then click...
Does the nRF52840 support Bluetooth low energy power control? I am using raspberry pi, running Raspian, kernel version 5.15.30 and I am specifically referring to the product...
