I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
In the nordic,nrf52840dk_nrf52840.dts there is a part "chosen" that says:
zephyr,console = &uart0; zephyr,shell-uart = &uart0; zephyr,uart-mcumgr = &uart0; zephyr,bt-mon...
Hi All!
I am using nrf52833DK and able to program with segger studio and vs code studio extension of nrf connect sdk . Now the issue is that I have designed the custom board...
Hi Nordic :)
I followed last week the nice Webinar on topics : Nordic Distance Measurement library
I'm using two nrf52833 DK, and run on both nrf_dm sample zephyr...
Hi ,
I wanted to create SPI application for custom board as SPI master as nrf5340 . So I was building spi application as per slave pin configurations. So please help me...
Hi everyone,
Is it possible to change the initial tick count to simulate running freertos for 49 days insteed to wait this time in real ?
I work with the SDK15.3 and freertos...
nrf5340dk
sdk version v2.0.0
windows10 system
hello_world sample
prj.conf:
child_image/mcuboot.conf:
build result:
how can i check the flash size of the...
Hi,
Are there any examples or references available to read / write data into the external SD card using fs_read, fs_write?
The examples available in older SDKs are not...
hi support team,
NCS SDK is now available, customer need to use cmd line tool to build demo and flash;
but find out that we have to open cmd through "nrf connect--->toolchain...
Hi,
I'm having difficulty getting a clean MCK when configuring passthrough (bypass) mode. I'm using ACLK as the source and I do get a 12.288MHz signal on the MCK pin but...
Hi all
In development with nRF91 and my application need to using an external flash memory to store the firmware and I try to follow the example this link below.
https...
Hi, I'm developing an application using internal flash memory. I based on flash_fds example to implement this feature. Now I can write and read data from flash. My basic feature...
Hi,
I have a board using an off the shelf nrf52811 module (from raytac). The only things on the board are the recommended 32k crystal with 2x 12pF caps, as well as two...
Hello,
I've been trying to get my call to app_uart_put() to actually place bytes on the TX pin. Interestingly enough, my call to app_uart_get() works fine and is able...
