Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi everybody,
I am currently testing the nRF9160-DK board with a M2M SIM from the provider "Things Mobile" (iBasis does not offer his services in Italy).
Issue:
the...
Hi all After successful installation of an update with the hep of dfu_target module, I am expecting the bootloader to swap the image and boot the new image with swap_type...
Hello! I have a nrf52840 DK. I am trying to build a custom keyboard on that SoC. I was able to compile and install nRF Connect SDK example on my DK. Everything works! ZMK...
Hello,
In continuation to the ticket: https://devzone.nordicsemi.com/f/nordic-q-a/70795/replacing-s140-with-s340-softdevice
I'm trying to switch between S140 and S340...
Hi,
I think I found a BUG about SPIM SDK15.3. The following is what I set the configurations for the SPIM0:
Then I use this function to active one transfer which just...
Hi,
I'm using nrf connect SDK 1.7 and following below guidelines to add I2C.
https://devzone.nordicsemi.com/nordic/nrf-connect-sdk-guides/b/peripherals/posts/twi-ic2-implementation...
Hi,
we have few queries regarding lighting mesh models support in ncs1.6.1
we were using NCS1.6.1 for mesh development
we were facing some compilation issues with LC...
I am using nRF52840 Dongle as Sniffer using Dongle. But when it captures the advertising packets,i am not able to see the preamble in the decoded packets. Please help!
Hello Everyone
I am really new to everything here, i just got nRF 9160dk board.
Can anyone please tell me the step-by-step method on how to make a very simple program...
Hello DevZone,
I am planning on making a system that uses peer manager ranking to determine which oldest bond I need to delete to make room for a new one.
I am using...
Hi Team,
we're developing firmware to send long range beacon by using LECODED phy channel. We notice that there is increase in energy consumption during advertising and...
Goal: Using NRF9160DK board, communicate nrf9160 and nrf52840 over UART
I tried to use UARTE on both sides. Below is project configuration and overlay file for both boards...
Hi,
I was using the AWS-IOT example and all was working until it wasnt. In troubleshooting this, I loaded the modem shell example, to see if it was a network/connection...
