I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hello All,
There are several issues where I can see RTT viewer is not working along with nrfjprog tool etc....
I am also facing similar issue where RTT viewer(version...
Hi,
While I can find many discussions about how to set the MAC address using the soft device API with previous SDK's, I cant find a way to change the MAC address of the...
New nRF52-DK PCA10040 2.1.0 2021.24
The out-of-the box "Get Started" procedure where I move my iphone near the antenna did not work (did not pop up any web page). NFC was...
Hi,
I'm leveraging the ble_app_cli example program for my project. The primary reason for this is that I need BLE and I need to be able store and retrieve log data which...
I'm downloading a firmware image from AWS via cell onto the nRF9160. I want to perform a serial DFU over UART. The DFU target is the nRF52840. Are there any existing samples...
Hello DevZone,
I want to send a simple AT-Command like: AT\r\n from the ESP32 to the Fanstel BC805M (nRF52805M) breakout board.
Problem : The Esp32 does not get a...
When handling a `BLE_GATTS_EVT_WRITE` from a queued write, the write event has the characteristic handle set to zero. How can I identify what characteristic is being written...
Hey there!
I'm new in the development with the nrf9160dk. And I wanted to connect the Murata SCL3300 digital inclinometer to the development kit via the SPI lines. However...
It's been a while since this Java developer really understood EE concepts.
Could someone jog my skills and explain to me roughly what the different pin rive modes are,...
Hi,
I need to send custom messages to models on my devices and I need to use a vendor model like I've seen other people on this forum use. But when I load the nRF Mesh...
Hello,
We are interfaced the nrf52811 with LSM6DSO32 through i2c and LSM6DSO32 is connected to Auxiliary(Temperature MAX30208) sensor through mode 2 connection. here I am...
I am trying to learn to use the nrfx API to control the nrf5340.
My installation is the NCS 1.6.0 with SES on OSX
It seems like nrfx most of the API devices are supported...
I'm trying to find a battery for my application and I need to know the max (peak) current draw for the nRF9160. On page 63 of the user guide, the max is 435mA with the specs...
