Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hi all,
I have been learning and doing research trying to estimate the range of a bluetooth chip. So far I've got to use Friis Transmission Equation to estimate the distance...
Hi, dear all:
I’m trying to use usbd_msc example(nrf 52840 DK/sdk 17.0.2 ) and written a string A (8 bytes) into a .txt file；
Now I want write the same file another string...
Hi,
I've recently added BT to my application and switched from S210 to S310 Softdevice. My Ant+ part is based on the HR RX example in SDK10. My BT part is basically copied...
Hello Everyone, I am generating firmware hash using an hash function provided by an external library and using CODE_START and CODE_SIZE macros in app_util.h , So i wanted...
Hi,
We are currently testing the zigbee_light example for nrf52840dk. Once in the debug stage, if we pause program execution and then resume it we find out that codes gets...
Windows 10
nrfjprog version 10.10.0
jlink mini - connected to Windows 10 USB port, try to run any nrfjprog command and it says there is no debugger connected to PC.
...
EDIT: I incorrectly reported the Secure Bootloader pca10040_s132_ble_debug .hex file included in SDK 16.0.0 wrote to addresses in the mbr_params_page, I have since identified...
Hi,
I am using ncs 1.5.0 and modem firmware version 1.2.3.
if I keep CONFIG_HEAP_MEM_POOL_SIZE=8192 then my application runs without any issue but
If I set CONFIG_HEAP_MEM_POOL_SIZE...
Hello,
We are implementing NFC functionality on our product. Specifically we're using the Type 4 Tag (Read/Write). Are there any compatible NFC reader/writer modules? I...
In my product I use certain GPIO pins configured as input with the pull up activated to act as sense inputs connected to momentary switches to control the application firmware...
Hi all
I have developed a project on the nRF51-DK board based on the proprietary RF protocol.
Now I have a custom PCB board always with an nRF51822 but only equipped with...
Hi, im running the sdk version 1.3.2 and Im experencing a system crash after calling
spm_request_random_number after the 4th or 5th time
I've already done some research...
Hi i was trying to use simple mqtt sample provided as example with location " ncs/nrf/samples/nrf9160/mqtt_simple" the code was build and run but during lte connection it...
