Hello,
Does anyone have a suggestion for a production programmer for the nRF24LE1 One Time Programmable version? I have been able to program the units with the nRFGo Studio...
GOAL: To send one 20-byte data packet from an Android Galaxy S5 to nrf51822 and send three 20-byte packets from the nrf51822 to the S5 in a single connection interval of 10...
Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130. Does anyone tried to...
hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hi all,
We have a custom board based on nRF52840, and we are using the nrf52840 DK to program our board(For programming the chip, connection from DK to our board is made...
Hi.
Device : nRF52820
SDK 17.0.2 ( Softdevice 7.2.0)
I initialized the clock as below to use USB.
And before changing to sleep mode, the clock was stopped to...
Hi，
So I was using nRF52810 with epoxy or resin coated，but actually the signal quality did not match my needs, the signal faded about 20dB compared to the device which not...
Dear Members,
I manage to display data from GSC10 sensor ? but after few minutes in idle, it can not receive a data anymore,
How can I restart again ?
Is it related...
I am using the nrf52-ble-app-uart-c-multilink-master getting data from 4 UART peripherals that are connected. Once one of the clients disconnects, I am getting an error as...
I have a custom board using nRF52840. Some boards return success from sd_ble_gap_adv_start but no advertisement is seen in nRF Connect running on a Google Pixel 4 phone. Of...
Hello,
I need help with my application.
I am developing an application running on the EV board nrf9160dk_nrf9160 .I read the following article:
http://194.19.86.155...
Hi,
I am developing an application that needs to communicate with nrf51 module over BLE. Specifically I need to write a string on a given characteristic but unable to do...
Hi all,
I was going through the nRF Connect SDK tutorial and was trying to get the "Hello World" example running on a nRF5340-PDK (PCA10095, 0.8.0).
Before that I was...
Hi
i was trying to setup spi_2 for external sensor interface with nrf9160-dk but even after setting CONFIG_SPI_3=n and CONFIG_SPI_2=y the spi_2 enabled but spi_3 isn't changing...
Hi, I try to implement adding a custom service to the BLE GATT stack by following this tutorial , but I faced a problem which looks like a linking problem
So far, I finished...
I am testing the "ble_app_hids_keyboard" program on the nRF51822 Evaluation Kit. I changed the pin assignment in nrf6310.h and it compiles fine. When I run the program it...
