Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
nrf5340dk
sdk version v2.0.0
windows10 system
hello_world sample
prj.conf:
child_image/mcuboot.conf:
build result:
how can i check the flash size of the...
Hi,
Are there any examples or references available to read / write data into the external SD card using fs_read, fs_write?
The examples available in older SDKs are not...
hi support team,
NCS SDK is now available, customer need to use cmd line tool to build demo and flash;
but find out that we have to open cmd through "nrf connect--->toolchain...
Hi,
I'm having difficulty getting a clean MCK when configuring passthrough (bypass) mode. I'm using ACLK as the source and I do get a 12.288MHz signal on the MCK pin but...
Hi all
In development with nRF91 and my application need to using an external flash memory to store the firmware and I try to follow the example this link below.
https...
Hi, I'm developing an application using internal flash memory. I based on flash_fds example to implement this feature. Now I can write and read data from flash. My basic feature...
Hi,
I have a board using an off the shelf nrf52811 module (from raytac). The only things on the board are the recommended 32k crystal with 2x 12pF caps, as well as two...
Hello,
I've been trying to get my call to app_uart_put() to actually place bytes on the TX pin. Interestingly enough, my call to app_uart_get() works fine and is able...
Am currently trying to implement a client UDP socket application with Mbed DTLS using a Pre Shared Key.
PSK and PSK_ID array values are defined as:
static const unsigned...
Hi,
I am using Thingy 91 in Australia, and I have linked Asset Tracker v2 with overlay-lwm2m.conf to communicate with my own LwM2M server, which is running an instance of...
I'm working towards getting an app derived from MQTT Simple to talk to AWS where I both need to validate the hostname via TLS, and also use public/private certificates to...
Several have asked about this basic situation but I have found no definitive answer.
I erased a dongle with a Segger J-link, and compiled the zephyr samples using CONFIG_BOARD_HAS_NRF5_BOOTLOADER...
