GOAL: To send one 20-byte data packet from an Android Galaxy S5 to nrf51822 and send three 20-byte packets from the nrf51822 to the S5 in a single connection interval of 10...
Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130. Does anyone tried to...
hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello,
I want to add the Thingy 91 to the nRF Connect Cloud. The SIM was activated correctly. I've inserted the SIM card and know I'm waiting for the LEDs to blink yellow...
Hi, I am using the UART over BLE example + a timer interrupt + a pwm signal. And I am facing the following problem (error launched by my phone app: ) This happens sometimes...
Hi ,
In order to capture and get the data from the external BLE beacons,
I am trying to simulate this using nrf connect Advertiser option instead of using Beacons...
Hello, i have been unable to read data from my sensor.
uint8_t SPI_ReadByte(uint8_t RegAddress) { ret_code_t retCode = NRF_SUCCESS; //start reading sequence m_tx_buf[0...
The modem reports that it supports states 0, 1, 4, 20, 21, 30, 31, 44 when I give the "AT+CFUN=?" command.
Using the at_client sample, or other software like asset_tracker...
Hi, I am using nRF52 DK with s112 and SDK V15.2.0. I have written an application based off of the uart example, and expanded it rather substantially to use the SAADC and read...
Hi,
I'm trying to create my switch_event by using Event Manager.
And I got this issue: "undefined reference to `__event_type_switch_event' " when submitting my event:...
Windows 10, Segger V4.52c, S132, SDK 15.2.0, nRF52832
I've been through a few posts talking about needing more RAM allocated to the SoftDevice when other services are added...
Is it possible to generate a DFU package for both bootloader-only and fully-programmed (bootloader, softdevice, and app) chips? I'm unable to do so for an nrf52833 using nrfutil...
Converting old code for a nRF51822 to the new SDK(15.3.0) for an nRF52832, this error happens:
#error "Compiler generates FPU instructions for a device without an FPU (check...
Hi all,
After wasting so much time trying to set up simple peripheral device whitelisting single central device, I realised that API has been updated and those old examples...
Hi all,
Can I read the chip ID of NRF24LE1 in code? how can I get the ID?
Or is there any readable identifier that make each chip "unique" from each other? Because the...
