In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hello,
I would like to have more info about canceling the pairing request on iPhone (thru the popup that asks if you want to pair with the device which is managed by iOS...
Hello everyone, I'm severely struggling to perform a simple task. I must be missing a very simple answer and, I hope with your help that I resolve the issue.
I am trying...
if the issue can be worked ,how to do that with android source code? the 2 ble pure devices (not android phone) connect with a ble android phone.
please check below, the...
Hello, I've stumbled about a problem with the NrfConnect extension and Kconfig. It is quite simple: When a project directory contains a Kconfig file, it is used by west as...
I'm a bit confused by the "unidirectional" solutions offered as examples / documentation for the nRF5340 DK. I would like to build a BLE Audio headset that both receives and...
Hi
How is the ESB_EVT_IRQHandler started? NVIC_SetPendingIRQ(ESB_EVT_IRQ) is registered with on_radio_disabled(), but I don't know how to be started this handler in the...
Hi:
I use ncs 1.9.1, borad nRF9160-DK
sda-pin = <30>; scl-pin = <31>;
Config:
I added i2c2 in blinky, here is the source code.
I see i2c2 enabled in...
Hello,
I am experiencing issues with an nRF5340 DK. I would like to try the matter samples but every time I flash one of them, it results in fatal error and reseting loop...
fota_download_start copies the file but not host string into a static buffer. The comment implies that the download_client only requires this for the file path, though it...
Hi everyone, i have some problems with firmware and i hope someone can help me. I am using nRF52840 microcontroller and SEGGER Embedded Studio. Also I'm using the littlefs...
Hi ,
I want to use a pin on board, which is not used or initialized in dts file . my requirement is that I want to initialize that pin before booting process. ( that pin...
Hi,
I am using the :
bt_scan_filter_add (BT_SCAN_FILTER_TYPE_MANUFACTURER_DATA, &mfgData);
scan-filter works well.
However, keeping everything same, if setting...
Hi,
I have been working on the display from JDI LPM027M128C with the nrf52840 development kit. By consulting the datasheet of the display, it seems to work with the spi...
hi :
can you help me to solve this problem. The path of the example is bellow：
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fsdk_nrf5_v17.1.0%2Fexamples.html&cp...
Hello,
I am trying to work with the MCUBoot bootloader in my project. I was able to configure and build my project and it appears to run properly when I flash it to the...
I have a nrF52840-DK and would like to try some precompiled test, but I got an error when copying a hex file to it. The error message is that The currently active SWD interface...
