How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
I have two custom PCBs, each of which has a microcontroller and an nrf24L01+. Everything related to the transceiver in the designs are complete duplicates (with the exception...
Hello,
I've built a small BLE-device based on the nrf8001.
With my Iphone I can discover this device and I am able to connect to it and listen to notifications of the...
Our pcb is used for gps location data. We have a nrf24L01 nordic chip as the micro process or between the gps module and wireless module (2G). Our engineer needs to capture...
Hi, I have some problems in using app_timerv2.c. I found that the timerv2 doesn't work without softdevice. I use SDK 17.10. I had found the article which name is nRF5 SDK...
The nRF connect for vscode extension pack is too hard to use. Is it hard to improve after such a long time of research and development?
Why don't you use segger embedded...
Using Segger version 5.10. As we found that only this version can work with the SDK17 we use for BLE application. We tried the latest version and latest sdk but we could not...
Hi,
I'm working on:
Mac mini M1
macOS Ventura 13.1
In Visual Studio Code (1.74.2) / nRF Connect extension, I create new application with following params:
...
Hello developers, I am using nRF52833 chip for Bluetooth Mesh sensor application In Kconfig I am setting TX POWER transmitter power at +8dbm. According to the device specifications...
I'm working on a project that uses s122 for nrf52833 in the nRF5 SDK. I want to do FOTA in this project. When I examined the flash layout for the bootloader in Nordic Infocenter...
Dear Nordic devzone community,
I am using nrf connect SDK version 1.8.0 for the asset tracker and 2.0.2 for AT client. IDE is Vscode Studio.
I have designed a custom board...
Hi,
ncs v2.2.0, sample central_uart.
It define NUS UUID as scan filter to connect peripheral_uart.
If I want to change the UUID value for scan filter to another value...
Hey there,
We are currently evaluating the nPM1100 to power several circuits (nrf52, IMU, LEDs).
Our device is tiny, and we want to use a coin-cell battery ( ML2020 from...
Hello,
I am using EMDS to store data to flash under certain conditions. The implementation is pretty basic and follows the specification and example in the SDK (v2.1.2)...
Hello nordic team ,
We are using nrf5340 DK and below mentioned are the Specifications used:
1) Visual studio code
2) nRF5340-DK hardware board (PCA10095)
3) Flash...
Hi,
I am currently trying to use SPI for the nrf9160. I tried building the SPI_BITBANNG sample for the nrf9160dk_nrf9160_ns board for the nrf9160dk that I have.
However...
Hello everyone,
Can someone help confirm if the Timer and PWM modules on nRF52840 can only use the high frequency (HF) clock source (1 MHz or higher) and cannot run from...
