Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
nRF52840, nRF Connect
I was looking at the button example and it is apparently a little different then in the nRF5 SDK kit. In the SDK you had a callback and inside that...
Hi!
For a custom project, I need to enable and disable soft device on a peripheral. I'm able to enable/disable softdevice for two cycles, then I get this error:
<error...
Hi,
I'm trying to mount two spi flash device on spi0, but can't found the second one(device_get_binding() return NULL).
The two device has compatible ("jedec,spi-nor"...
Hello Support,
In my project I use the nrf52840 with the nRF Connect SDK to create a OpenThread device with an Secure MQTT connection to a broker.
I've got the OpenThread...
Hi. I am trying to output a square wave on to separate output pins. I want to have one inverted, however I can't even get the same output on both pins at the moment. The pin...
I want to use HCI_USB on nRF52840 board(nrf connect SDK).
Legacy Advertising Scan is success.
But,, I don't know how to recieve the Extended Advertising Scan.
Please...
We have an nRF52840 operating as BLE peripheral that ix using sd_ble_gatts_hvx() to notify an attribute value. Because we are using an RTOS, after calling sd_ble_gatts_hvx...
Good morning,
DK: nrf5340 Audio DK
SDK : V2.0.0
Toolchain Manager: V1.1.3
nRF Connect for Desktop: v3.11.1
I am trying to work with nrf5340 Audio DK. I was able...
Hi,
I was working with my Thingy:91 all worked fine. Wanted to upgrade to latest firmware and somehow in this process the USB interface stopped working. I switched to use...
hi,
i am using sdk_17.0.2 and nrf52840.
I want to get 6 pwm outputs like in the picture.
They all have to start at the same time.
20 khz signals should be.
i...
