Hey folks,
I'm trying to modify the SPI Master loop back example into a 4 line SPI Master_Slave program. Whenever I change the Tx_Buffer_lenght from 10 to lsome other numbers...
Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
I am working on creating a Bluetooth Mesh network using the BGM220P as a sensor node. My goal is to send sensor data (e.g., temperature) from the BGM220P and have it received...
Hi
I am having some issues flashing the modem firmware to a custom board using the nrf9151 SiP.
I can, with no issues, flash programs to the chip, but when i want to...
Hi.
I'm playing with an scenario based on two nrf52840dk and a dongle.
I have deployed a OTBR on a Linux Ubuntu22.04 and flashed the dk with OT COAP Server and Client...
After a lot of help, I've managed to get a central_uart with custom UUIDs going. After stripping out as much unwanted code and callback functions as possible, moving UART...
Hi,
I am new in Device tree concept. I am trying to operate a buzzer via PWM.
In our board, the buzzer is connected in GPIO 3.
I changed a segment in file nrf52dk_nrf52832...
Hello,
At the moment I have a correctly working Azure IOT hub connection.
DPS works, device twin configurations works and transmitting data to the hub is also no problem...
Hi All I started on the fundamental course in the academy. I did everything by the letter in lesson 1 / exercise 1 Yet when I plugged in my 52840 devkit I could no load the...
Hello,
I am working on a project involving the nRF54L15dk and need to connect a peripheral's reset pin to the reset functionality of the DK. However, I noticed that the...
This is heavily processed code just to show what I'm doing with discovery: I can see that first time I call for discovery I get BT_GATT_DISCOVER_PRIMARY cnt_3 = 3. Then I...
I discovered this chipset and have found a dev board on eBay for $37. Is it worth it to tinker with? I have the 2.8 version of the toolchain. And Sdk. On vs code.
I have...
Why are RADIO_MODE_MODE_Ble_LR125Kbit ， RADIO_MODE_MODE_Ble_LR500Kbit and RADIO_MODE_MODE_Ieee802154_250Kbit not supported in the ESB routines? If I want to use these configurations...
Hi,
I'm working on a project where I want two units to be able to wirelessly send packets to each other whenever they need to. Sometimes only one of the two units may be...
If I initialize the IPC and then turn on the bt_enable, it will lead to the status quo in Figure 2, what is the reason?
If I block k_sem_take (&bound_sem, K_FOREVER) and...
