Hello all,
in my previous question (Switch between applications (multiple services.h)) I got the advice to merge my two services into one service, including a HID over...
I am trying to create an nRF8001 based application that will broadcast battery levels (pipes broadcast, set), and give out temperature data (pipe indicate - TX_ACK) to connected...
Hi,
I'm using redbearlab's nrf51822 board. It is a arduino compatible board and hence it is using 0,1 (mapped to 9 and 11 for nrf51822). How do I make printf print to this...
An external PA/LNA is used to extend range of nRF51822, and S110 is used for BLE, How to switch between PA and LNA? and how to disable PA/LNA when there isn't transceiving...
Hi...
Can anybody help me to run ble_peripheral example (ble_app_hrs for S130). I have build and load the code successfully but cant see the advertisement. But while debugging...
I am working with the nRF8001, and I'd like to create a services.h file that will let me broadcast battery level and as well as allow temperature to be read by a peer.
...
Hi We have an application where we what to read i2c sensor data over the air to an iPhone. We've taken ble_app_uart_S130 project and grafted in some twi_hardware code. There...
Hi, I used NRF52 DK and NRF Connect SDK 1.6. I used the st_ble_sensor sample with no changes. When I press Button 1, I expect to get a notification on the central device....
Is there a straight forward guide that demonstrates how to changes the Asset Tracker V2 application from "Active Mode" to "Passive Mode"?
Referencing the notes on the application...
Hello,
I have been working with nRF52832 microcontroller on a custom PCB. Currently, we are implementing OTA updates through BLE, and developing using the nRF toolbox app...
Hi,
I am trying to program the nRF52 DK with external j-link Base. I am using Debug IN P18 connector and connected the following pins
j-Link base nRF52 DK Debug IN P18...
I'm a little confused about how to determine the value to set in the registers for the internal capacitors. If I select 10pF, that means that there is an internal C1 and C2...
Hey everyone,
I basically have the same question as it was discussed in this ticket: How to get unicast address on mesh server. - Nordic Q&A - Nordic DevZone - Nordic DevZone...
Hello, I'm currently planning a product that involves Bluetooth technology and came across the NRF5340 chip. I see that I can get the development kit which is a board with...
Hi,
On nRF5340 development board I followed the instructions in this link and ran the blinky example successfully: Getting Started Guide — Zephyr Project Documentation...
I got an error here err_code = pm_init(); APP_ERROR_CHECK(err_code);
<error> nrf_ble_lesc: nrf_crypto_ecc_key_pair_generate() returned error 0x8502.
<error> peer_manager...
I am using the BLE sniffer in Wireshark (nrf 52840 dev kit board) to attempt to capture packets between a BLE device and android phone. I am able to sniff advertising packets...
Hi,
I have faced an issue with cmsis_v1 thread creation/removal with the SDK connect.
I have created the following ticket on zephyr's side and attached the patch I'm...
Hello,
How to find NRF connect mobile app server's address in the app to be used for connecting to peer devices ? Is there any way that the device address does not change...
